Auxiliary carry fla - registers, Electrical Engineering

Assignment Help:

Auxiliary Carry Fla - Registers

If carry  is generated  from D3  to D4 in the accumulator after any arithmetical or logical  operations. Auxiliary  carry flag (AC) is set otherwise reset. This  flag is  used  internally by the microprocessor  for BCD operations  and cannot be  used by  the programmer.

 


Related Discussions:- Auxiliary carry fla - registers

Three phase transformer., Dry type 10KVA-3ph-440/230v Dyn11. If we decide t...

Dry type 10KVA-3ph-440/230v Dyn11. If we decide to wound above such specification, what current to be taken i.e. phase current or line current 7.57A or 13.12A

Addressing model , Addressing Model As we have learned  already  that ...

Addressing Model As we have learned  already  that each instruction has two  parts  one is  op code and another  is operand. Op code  specified  the type  of operations to be

Explain total internal reflection, Explain Total internal reflection? T...

Explain Total internal reflection? The refractive index of a medium is defined as the ratio of velocity of light in vacuum to the velocity of light in that medium n x = C/V

Estimate the required bandwidth using Carson''s rule, A 10-kHz tone is used...

A 10-kHz tone is used to frequency modulate a carrier; the peak deviation is 75 kHz. Use Carson''s rule to estimate the bandwidth.

Circuit theory, derivation for two watt meter method

derivation for two watt meter method

Write notes on clamping, Q. Write notes on clamping ? When a signal dr...

Q. Write notes on clamping ? When a signal drives an open-ended capacitor the average voltage level on the output terminal of the capacitor is determined by the initial charge

MATLAB, Future scope on MATLAB in India

Future scope on MATLAB in India

Clippers, Which clipper would you prefer between the series and the shunt c...

Which clipper would you prefer between the series and the shunt clipper? Why?

Can you explain about slew rate, Q. Can you explain about Slew Rate? Sl...

Q. Can you explain about Slew Rate? Slew (or slewing) rate is a measure of how fast the output voltage can change. It is given by the maximum value of dvo/dt , which is normall

Explain about stored program control, Q. Explain about Stored Program Contr...

Q. Explain about Stored Program Control? Stored Program Control:   In centralized control, all control equipment is replaced by a single processor which should be quite powerf

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd