Description of the program counter and the data pointer, Electrical Engineering

Assignment Help:

Questions:

a) Give a brief description of the program counter and the data pointer, including their differences.

b) Briefly describe what are Byte-Level logical operations and Bit-Level logical operations.

c) Identify three ways how to reduce cost in embedded systems.

d) Briefly comment on the "A" register and the "B" register of the 8051 microcontroller.

e) Briefly describe the concept of "Moving Data" in an embedded system.


Related Discussions:- Description of the program counter and the data pointer

Explain the transfer characteristics, Q. Explain the transfer characteristi...

Q. Explain the transfer characteristics in a few words ? The transfer characteristics are a plot of an output (or a drain) current versus an input controlling quantity. There i

Hexadecimal number system, Hexadecimal Number System Similar  to octal ...

Hexadecimal Number System Similar  to octal number hexadecimal number system is also used to represent long  binary  numbers in  smaller  form. In microprocessor  we use  hexad

Literature review - software defined radio, Literature Review - Software De...

Literature Review - Software Defined Radio In this section, first two methods to estimate signal to noise ratio (SNR) are reviewed and a few methods for modulation classificati

Write a note on the application of emitter-follower, Q. Write a note on the...

Q. Write a note on the application of emitter-follower? An emitter follower can serve as a buffer for a voltage source. The voltage divider at left is a poor voltage source bec

Torque required to turn a self excited generator, Work must be done against...

Work must be done against the electromagnetic torque in order to generate the voltage (and current) supplied to the electrical load connected to the generator. Therefore energy con

Power flow analysis, Ask question #Minimum 10] In the system shown in Fig...

Ask question #Minimum 10] In the system shown in Figure 4-1, the rated voltage of the line is 110kv, and the conductors are all LGJ-120 type. The parameters are: r1=0.21O/km,x1=0

Electronic instrumentation and measurements, why is a delay line used in th...

why is a delay line used in the vertical selection of oscilloscope?

What are the kinds of transformations, What are the kinds of transformation...

What are the kinds of transformations? Illustrate each with the help of homogeneous matrix form in 3-D.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd