Define the skid fabrication, Mechanical Engineering

Assignment Help:

Q. Define the skid fabrication?

Unless noted otherwise in this specification, skid fabrication shall be in accordance with GS-904-0510, GS-904-0511 and GS-904-0515.

Dimensional tolerances shall be within 6mm for overall skid dimensions. Other tolerances shall be as per specification GS-904-0509, GS-904-0510 and GS-904-0520.

Skid mounted assemblies, including piping, guards, ladders, platforms and railings, shall be erected prior to coating. If disassembly for shipment or field erection is required, Vendor shall supply and install all necessary clips and furnish all necessary connection materials (i.e., bolts, nuts, washers), plus an additional 10%. Loose pieces shall be tagged for location and secured to main skid.

Equipment and vessels weighing more than 135kg dry weight shall be mounted on pads at least 12.7 mm thick that are welded directly to the top of skid structural members. If supplied, floor plate shall be cut back and seal welded around pad penetration.

Skids shall have vertical jacking screws along outside of main longitudinal members at pile locations when more than two skids are to be installed adjacent to each other.

Elevated platform decks and walkways shall be open steel serrated bar grating and shall be bolted in place for easy removal and cleaning.

All piping, valves and equipment shall be supported and anchored to avoid undue stresses and vibrations during shipment, as well as during normal operation. Supports shall be seal welded.


Related Discussions:- Define the skid fabrication

The leader command-autocad, The Leader Command The Leader command can b...

The Leader Command The Leader command can be used to annotate at any point on a drawing. The command sequence below was used to draw the leader shown in the Figure Below.

determine the minimum cross section area of graph, To design a cantilevere...

To design a cantilevered truss to support the loads shown in the figures, two layouts are proposed as shown in Figs. A and B. All truss members are steel with allowable stress of 2

Equipment for resistance welding-single phase vs three phase, EQUIPMENT FOR...

EQUIPMENT FOR RESISTANCE WELDING-Single phase vs three phase The resistance welding machines can be connected either across 440 V mains (across two lines) or three phase mains.

Suspension system, Suspension System, Wheels and Tyres:  There are numerou...

Suspension System, Wheels and Tyres:  There are numerous types of suspensions for connecting the wheels to frame body. The suspension plays the vital role in handling and driving

Computer control system in flexible manufacturing system, Computers control...

Computers control system in flexible manufacturing system

What is pedestal and what are uses of pedestal, What is pedestal? What are ...

What is pedestal? What are uses of pedestal? PEDESTALS A pedestal is used to transfer the loads from the metal columns through the floor and soil to the footing when it is a

What is the net angle of twist at the free end, What is the net angle of tw...

What is the net angle of twist at the free end: The stepped steel shaft illustrated in Figure is subjected to a torque (T) at the free end and a torque (2T) in the opposite di

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd