Define diffusion length, Electrical Engineering

Assignment Help:

Define diffusion length:

Sol. Diffusion length is defined as the distance, travelled by free carriers before recombining. It may also be defined as the average distance covered by an excess carrier during its life time is π. The mean time that a carrier exists between it, undergoes recombination is called mean life time. The mean life time and the diffusion length L are related to each other.

 


Related Discussions:- Define diffusion length

Define the xor gate - microprocessor, Define the XOR GATE - Microprocessor?...

Define the XOR GATE - Microprocessor? The XOR GATE is a alike to an OR gate except for the instance when all the inputs are high. With a XOR gate when all the inputs are high t

System diagram of complex programmable logic device, The system diagram for...

The system diagram for the proposed unit is shown below. The system operates on the principle of Time to Rate Conversion. Signals from the heart beat sensor are amplified

Show noise and stability of operational amplifier, Q. Show Noise and Stabil...

Q. Show Noise and Stability of operational amplifier? Noise This refers to the small, rapidly varying, random spurious signals generated by all electronic circuits. Noise

Principals applied in product design, What are the broad principals that wi...

What are the broad principals that will be applied in product design to facilitate automated assembly ?

Mobile and wirelss communicatio, In a CDMA system, the signal is spr...

In a CDMA system, the signal is spread over a large bandwidth by multiplying the transmitted symbol by a sequence of short pulses, also called chips. The

Determine the cross-sectional conducting area, Q MCM is the abbreviation fo...

Q MCM is the abbreviation for 1 kcmil. problem for a de?nition of cmil.) Data for commercial-base aluminum electrical conductors list a 60-Hz resistance of 0.0880 /km at 75°C for

Define lines parameters, Define Lines Parameters In power system analys...

Define Lines Parameters In power system analysis, the parameters of interest when modelling power lines are:  inductance, capacitance, series resistance and leakage resistance.

Product of two sinsoids, Connect the two signals used in section 2 above to...

Connect the two signals used in section 2 above to the "Multiplier" module. Make sure that you record the amplitude of each signal. Observe and record the resultant waveform in

Transformers, Are you able to give a list of factors that could be consider...

Are you able to give a list of factors that could be considered as the transformer''s characteristics?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd