By which ferroelectric materials are characterised, Electrical Engineering

Assignment Help:

Ferroelectric materials are characterised by

(A) Very high degree of polarisation.

(B) A sharp dependence of polarisation on temperature.

(C) Non-linear dependence of the charge Q on the applied voltage.

(D) All the above.

Ans:

Ferroelectric materials are characterised through very high degree of polarisation, a sharp dependence of polarisation upon temperature and a sharp dependence of polarisation upon temperature.

Related Discussions:- By which ferroelectric materials are characterised

Where does cpu enhanced mode originate from, Intel's 80386 was the first 32...

Intel's 80386 was the first 32-bit processor, and as the company had to backward-support the 8086. All the modern Intel-based processors run in the improved mode, capable of switch

Electronic monitor and alarm system for an oil separator, This assignment i...

This assignment is to develop a User Requirements Specification for an electronic monitor and alarm system for an Oil Separator in Surface Water Drainage Systems. These separato

Explain pnp transistor circuit, Explain pnp transistor circuit . pnp tr...

Explain pnp transistor circuit . pnp transistor: A transistor consist of three terminals. In this pnp transistor there is two blocks of p- type semiconductors that are separa

Calculate the time to get the voltage across the capacitor, 1. The circuit...

1. The circuit below will be most efficiently analyzed by obtaining the Thevenin equivalent circuit for the circuit to the left of the points (a-b) on the schematic. The capacitor

Analog computers, Q. Analog Computers? Although not used as much as the...

Q. Analog Computers? Although not used as much as the digital computer (which nowadays forms the basic tool for numerical analysis and the solution of algebraic as well as diff

Find the t- domain forced response, Consider an RLC series circuit excited ...

Consider an RLC series circuit excited by v(t) = Ve st in the time domain. Assume no initial capacitor voltage or inductive current at t = 0. Draw the transformed network in the s

MUX, Is it used to replace the basic gates ?

Is it used to replace the basic gates ?

Electrical science value2 of 4, discuss the generator action in a dc motor...

discuss the generator action in a dc motor

Explain working of biased clamper, Q. Explain working of Biased Clamper? ...

Q. Explain working of Biased Clamper? Biased Clamper : The circuit of a positively biased clamper is shown in the figure. During the negative half cycle of the input signal the

How linear sweep voltage is generated, Q. With a suitable block circuit, sh...

Q. With a suitable block circuit, show how linear sweep voltage is generated ? The above figure shows a basic sweep waveform generator. The switching action of the switch

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages