Cscc in gas streams, Mechanical Engineering

Assignment Help:

Q. CSCC in Gas Streams?

Due to process upset of FWKO or Treater, there may be chance of chloride carry over into the gas lines. Depending on the chloride contents of formation water, as these lines operate in high temperature, there is high risk of CSCC of austenitic SS.

If upgrading of metallurgy deem necessary as of the results of corrosion calculations, DSS shall be the prime material of choice.

Bitumen carry over into the gas lines is most likely in SAGD plants, therefore CS performs well and the risk of CSCC is minimized.

The FWKO should not be allowed to operate for a sustained period at high liquid levels since this can result in liquid or foam-carry over into the PG system when a slug hits.


Related Discussions:- Cscc in gas streams

Rockwell hardness test, Rockwel l Hardness Test: The specimen is subj...

Rockwel l Hardness Test: The specimen is subjected to a major load for about 15 seconds after the initial load. ASTM says 13 scales for testing of wide range of materials. Th

Bench vices tool and equipment , Bench Vices: Bench vice is used to hold a...

Bench Vices: Bench vice is used to hold a job on a bench. It consists of a movable jaw, a fixed jaw, spindle and a lever. Figure shows a bench vice. The movable jaw is in the fron

Spinal fluid collection, Spinal fluid Collection:    Spinal fluid is u...

Spinal fluid Collection:    Spinal fluid is usually obtained from lumbar region, although may be obtained during surgery from the cervical region or from the cistern or ventri

Describe the terms refrigeration and air-conditioning, (a) Describe the ter...

(a) Describe the terms "Refrigeration" and "Air-conditioning". Determine the units of Refrigeration ? (b) The capacity of refrigeration is 400 TR when working between -6 o C and

Wet saturated steam - thermodynamics, Wet saturated steam -  thermodynamic...

Wet saturated steam -  thermodynamics: we t saturated steam Wet steam is a 2-phase mixture comprising of boiling water particles and dry steam in equilibrium state. Its for

Tempering and stabilization, Tempering and Stabilization: Tempering o...

Tempering and Stabilization: Tempering of tool steel in heat treatment is again a significant step. The quenching of such steels reasons the existence of untempered martensit

Green chemistry, what is green chemistry with diagram

what is green chemistry with diagram

Define the advantages of electro discharge machining, Define the Advantages...

Define the Advantages of Electro discharge machining 1. The surface finish obtained is very good. 2. This process can be used for any hard material. 3. Materials likes ca

Bund and dike capacity, Bund / dike capacity is typically covered by local ...

Bund / dike capacity is typically covered by local codes and regulations, however some general principles for liquid storage compounds are: • The net capacity of a bunded / dik

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd