Corrosion resistance of zirconium, Mechanical Engineering

Assignment Help:

Q. Corrosion resistance of Zirconium?

Zirconium offers excellent corrosion resistance to most oxidizing and reducing acids and virtually all alkalis. However, it is not resistant to hydrofluoric acid, concentrated sulphuric acid or oxidizing media containing halides.

Care must be taken to avoid the potential for conditions that may cause acid concentrations to increase above 70%.

Zirconium has the potential of developing a pyrophoric film in sulphuric acid service containing residual alcohol, ferric ions, chlorides or oxidizing cations. Appropriate gas freeing procedures, followed by a thorough steam-out, has been found to be a successful preventative measure.


Related Discussions:- Corrosion resistance of zirconium

Expression for the normal and tangential stresses, Expression for the norma...

Expression for the normal and tangential stresses: By sing Mohr's circle, derive expression for the normal and tangential stresses on a diagonal plane of material subjected t

Design a soda vending machine, Design a soda vending machine that can deliv...

Design a soda vending machine that can deliver three kinds of soda, A, B and C. All the three soda cost the same amount - 70 cents. The vending machine has four coin slots, one eac

Evaluate the resultant of magnitude and direction of force, Evaluate the re...

Evaluate the resultant both in magnitude and direction of the four force acting on the body as shown in figure given below :

Stress, Difference between direct and shear stress

Difference between direct and shear stress

Type of lubrication systems , Type of Lubrication Systems The complete...

Type of Lubrication Systems The complete lubrication of a vehicle can be divided into two systems. (a) Engine lubrication system. (b) Chassis lubrication system.

Determine the brake mean effective pressure, A 4 cylinder petrol engine ope...

A 4 cylinder petrol engine operates on the 4-stroke cycle. The bore of each cylinder is 70mm and stroke 100mm. The clearance volume per cylinder is 60cm3. At a speed of 4000rpm, th

Isentropic flow through the nozzle, Isentropic flow through the nozzle: ...

Isentropic flow through the nozzle: In an isentropic flow through the nozzle, air flows at rate of 600Kg/hr. At inlet to the nozzle, the pressure is 2Mpa and temperature is 1

Evaluate the stresses in the steel and concrete bars, A load of 2MN is appl...

A load of 2MN is applied on a short concrete column 500 mm x 500 mm. The column is reinforced with four steel bars of 10 mm diameter, one in each corner. Evaluate the stresses in t

Discover the suitable diameter of the shaft, Discover the suitable diameter...

Discover the suitable diameter of the shaft: A shaft is required to fail while the torque on the shaft is 20 kN-m. Discover the suitable diameter of the shaft of the modulus o

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd