Evaluate plant load factor, Mechanical Engineering

Assignment Help:

a) Illustrate principal of magneto hydro dynamic system (MHD) with diagram?

b) a thermal power plant has two 60 MW units each running for 8000hrs and one 30MW unit running for 2000hrs per year. The energy produced by plant is 876X106 KWH/year. Evaluate plant load factor and plant use factor. Consider maximum demand as similar to plant capacity.


Related Discussions:- Evaluate plant load factor

How many types of foundations are there, How many types of Foundations are ...

How many types of Foundations are there Foundations are broadly classified into two types, viz., shallow and deep foundations with respect to  the width (B) and depth (D) below

Calculate the natural frequency of the system, (a) A mass of 1 kg is to be ...

(a) A mass of 1 kg is to be supported on a spring having a stiffness of 9800N/m. The damping coefficient is 5.9 N-sec/m. Calculate the natural frequency of the system. Determine al

Optimization, consider the following LPP max z=9x1+8x2+5x3 subject to 2x1+3...

consider the following LPP max z=9x1+8x2+5x3 subject to 2x1+3x2+x3 5x1+4x2+3x3 x1,x2,x3>_0 (a)solve using simlex method (b)hence using the sesitivity analysis,find the new optima

Thermal, diference between thermal and thermodynamic equallibrim

diference between thermal and thermodynamic equallibrim

Determine the air standard efficiency, Compare the efficiency of Diesel, ot...

Compare the efficiency of Diesel, otto and Dual combustion cycle on the basis of same compression ratio and same heat input. In an otto cycle air at 17 o c and 1 bar is compressed

Yield stress and ultimate stress yield stress, Y ield stress and ultimate ...

Y ield stress and ultimate stress Yield stress: Yield stress can be defined as lowest stress at which extension of test piece increases without increase in the load. It is

What is expansion joints, Q. What is Expansion Joints? Expansion joints...

Q. What is Expansion Joints? Expansion joints are used to accommodate thermal growth in piping and pressure vessel applications. The metal bellows, an integral part of an expan

Submerged arc welding - set up, SUBMERGED ARC WELDING-Set Up Submerged ar...

SUBMERGED ARC WELDING-Set Up Submerged arc welding system consists of the following basic modules: 1. Welding head 2. Power source 3. Flux feeding and recovery units Schematic

Turnning fixtures, What are the forces coming on workpiece during turning a...

What are the forces coming on workpiece during turning and how workpiece should be clamp?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd