Continuous and salt bath furnaces, Mechanical Engineering

Assignment Help:

Continuous Furnace:

Parts to be treated are situated on several sort of conveyor that move into the furnaces as per to programmed heating cooling cycle. The time for unloading-loading is greatly saved and handling of job is decreased. For high production rate and better control of heat treating cycle these furnaces are more proper.

Salt Bath Furnaces

Salts baths utilized for heating ensure good control uniform temperature and high heating rates are compared to gas or air. The metals or molten salts have higher conductivity than gas or air. The salt might be heated from outside if it is non-conducting or via passing a low voltage alternating current among electrodes placed in the salt. Direct current is not employed since it is likely to reason electrolysis of salt. In between metals, lead is usually utilized. Wide range of temperature may be acquired from such baths.


Related Discussions:- Continuous and salt bath furnaces

Problems on structural design of combined footings, Problems on Structural ...

Problems on Structural Design of Combined Footings a. Two columns 50 cm x 50 cm in size support service loads of 1200kN and 800kN.The centre to centre spacing between columns

Show bolt material, Q. Show Bolt Material? Bolt material must be select...

Q. Show Bolt Material? Bolt material must be selected with adequate yield strength at the operating temperature to provide the required strength to properly seat the gasket. It

Braking system in motorcycle, Braking System: A brake is a component of a ...

Braking System: A brake is a component of a motorcycle which is used to apply frictional resistance to a moving vehicle to stop or retard it by absorbing its kinetic energy. The f

Reduce system to a single force - mechanics, Reduce system to a single forc...

Reduce system to a single force: Q: A system of parallel forces is acting on rigid bar as shown in the figure given below. Reduce this system to  a single force

Evaluate the actual over all efficiency of the turbine, (a) An engine uses ...

(a) An engine uses 6.5 Kg of oil per hr of a calorific value 30,000 kJ / kg. If the B. P. of the engine is 22KW and mechanical efficiency 85%. Calculate (i) Brake thermal eff

Governor, what is the formula of sensitivity of governor?

what is the formula of sensitivity of governor?

Cold pierce, Material S48C thickness 4mm pierce hole daimeter 4 mm can do o...

Material S48C thickness 4mm pierce hole daimeter 4 mm can do or not? please advise

Newton s rings, how i make assigment for newton s ring

how i make assigment for newton s ring

Evaluation phase of radial drilling machine, Evaluation Phase of Radial dri...

Evaluation Phase of Radial drilling machine Steps: 1. To judge the ideas generated in the creation phase for ability to meet the required criteria. 2. To refine, develop

Engineering plastics, Engineering Plastics In this time this has becom...

Engineering Plastics In this time this has become clear to know, the plastics are utilized as engineering materials for machine parts, casting and bodies and for structure mai

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd