Co2 gas supply-co2 welding, Mechanical Engineering

Assignment Help:

CO₂Gas Supply

The CO₂ shielding gas is supplied cylinders at high pressure (140 kg / cm²). Therefore pressure regulator and flow meter are connected to reduce the pressure to the required level (2 kg / cm²) and to control the flow rate of shielding gas from the cylinder. Gas hose connects the flow meters the solenoid valve. The solenoid valve, when actuated releases the shielding gas into the torch assembly.

Related Discussions:- Co2 gas supply-co2 welding

Torsion equation derivation, Torsion equation derivation

Torsion equation derivation

Find out ratio of upper end area to lower end area of bar, Find out ratio o...

Find out ratio of upper end area to lower end area of bar of uniform strength Sol : The figure given to us shows a bar subjected to external tensile load P. If bar had be

Find an approximated probability, Find an approximated probability: Si...

Find an approximated probability: Sixteen numbers are selected independently and at random from the interval [ 0, 1 ]. Find an approximated probability that the mean of these

Critical euler axial compression stress, Determine the minimum critical Eul...

Determine the minimum critical Euler axial compression force, Pcr and the minimum critical Euler axial compression stress, cru, for the column below which is pinned at the top and

Diffrence between external diameter and internal diameter, Diffrence betwee...

Diffrence between external diameter and internal diameter: A compound tube is built by shrinking one tube on another, the ultimate dimension being, 80 mm internal diameter, 16

Define the disadvantages of abrasive jet cutting machines, Define the Disad...

Define the Disadvantages of Abrasive Jet Cutting Machines Slow material removal rate. Stray cutting and hence accuracy is not good. Abrasive powder cannot be reused

Determine the normal stresses, Determine the normal stresses: A short ...

Determine the normal stresses: A short hollow pier 1.6 m × 1.6 m outsides as well as 1.0 m × 1.0 m intersides supports a vertical load of 2000 kN at a point located on a diago

Calculations for the force to move a block, Calculations for the force to m...

Calculations for the force to move a block: T wo blocks A and B having weight 4KN and 2KN respectively are in equilibrium position as shown in the figure given below. Coeffi

FEM, assignment help needed

assignment help needed

Coated electrodes and their classifications, COATED ELECTRODES AND THEIR CL...

COATED ELECTRODES AND THEIR CLASSIFICATIONS Welding technology has changed tremendously over the past decades. Its application is found in all sectors of industries, smaller or l

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages