Categorization of geometric models, Mechanical Engineering

Assignment Help:

Q. Categorization of Geometric models?

Modern CAD systems define objects in 3-D. Thus, the designer can construct 3-D model of objects conveniently and store the database of the model in the computer. Geometric models can be classified into three types :

(i)  Wire-frame model.

(ii)  Surface model.

(iii)  Solid model.


Related Discussions:- Categorization of geometric models

Plate clutch for warpage-clutch jerking, Plate clutch for warpage : Place ...

Plate clutch for warpage : Place plate clutch on surface plate and check for warpage. Ensure that 0.20 mm feeler gauge does not slide freely.

I want answer, #question. Select a standard rolled steel I-section for the ...

#question. Select a standard rolled steel I-section for the simply supported beam shown in figure below. Select an appropriate factor of safety and material strength. Include ref

Alloy materials control, Q. Alloy materials control? All low alloy and ...

Q. Alloy materials control? All low alloy and high alloy equipment components including fittings, flanges and sections of pipe and all welds shall be individually tested by Ven

Telescopic hydraulic fork , Telescopic Hydraulic Fork: This type of suspen...

Telescopic Hydraulic Fork: This type of suspension system is used to serve for front part of motorcycle. Figure (Front Suspension Fork) shows detailed view of front fork assembly.

Reduce system to a single force and couple, Reduce system to a single force...

Reduce system to a single force and couple: Q: A system of parallel forces is acting on rigid bar as shown in the figure given below. Reduce this system to  a single force

Calculate the power of the engine, A Torsion dynamometer is used in a prope...

A Torsion dynamometer is used in a propeller shaft of a marine Engine. It is found that the shaft twists 2 o in a length of 20 meters at 120 r.p.m. If the shaft is hollow with 300

Determine the work related area of cad, Work related area of CAD Work r...

Work related area of CAD Work related to the following areas has been addressed in this interface.  Investigation of CAD data structures and the presentation of 2-D and

Air standard cycles - thermodynamics, AIR STANDARD CYCLES - thermodynamics:...

AIR STANDARD CYCLES - thermodynamics: Most of the power plant operates in the thermodynamic cycle that is the working fluid undergoes a series of processes and returns to its

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd