Calculat ethe total amount of phase, Mechanical Engineering

Assignment Help:

Question 1

For an equilibrium cooled alloy of 92%D/8%C, which of the above diagrams best represents the microstructure at 0°C?

Question 2

For an equilibrium cooled alloy of 75%C/25%D, which of the diagrams above best represents the microstructure at 0°C?

Question 3

For an equilibrium cooled alloy of 15%C/85%D, which of the diagrams above best represents the microstructure at 195°C?

Question 4

For an equilibrium cooled alloy of 15%C/85%D, which of the diagrams above best represents the microstructure at 0°C? This is a difficult question. You will need to be careful in determining your answer.

Question 5

For an equilibrium cooled alloy of 40%C/60%D, which of the diagrams above best represents the microstructure at 595°C?

Question 6

For an equilibrium cooled alloy of 80%C/20%D at 0°C, indicate the total amount of á phase that is present.

Question 7

For an equilibrium cooled alloy of 75%C/25%D at 0°C, indicate the amount of primary á phase that is present.

Question 8

For an equilibrium cooled alloy of 80%C/20%D at 0°C, indicate the amount of primary ã phase that is present.

Question 9

For an equilibrium cooled alloy of 45%C/55%D at 0°C, indicate the total amount of eutectoid mixture that is present.


Related Discussions:- Calculat ethe total amount of phase

Thermodynamics, can u please explain me d concept of 2nd law of thermodynam...

can u please explain me d concept of 2nd law of thermodynamics. I am not so sure about it ??

Remove cover left crank case and check for leakage, Remove cover left crank...

Remove cover left crank case and check for leakage: Before attending oil seal leakage check if any leak is there in the highlighted points - Neutral switch "o" ring leak, Shifter

Determine force exerted on the plate, A nozzle of 50 mm. dia. delivers a st...

A nozzle of 50 mm. dia. delivers a stream of water that strikes a flat plate which is held normal to the axis of stream. If the issuing jet has a velocity of 15 m/sec., Determin

Pressure relief valve application, Q. Pressure Relief Valve Application? ...

Q. Pressure Relief Valve Application? A general comparison of operational characteristics is given for the different types of pressure relief valves in common industrial use.

Rich mixture-mixture requirement , Rich Mixture: It generally ranges...

Rich Mixture: It generally ranges from approximately 7 : 1 to 13 : 1 proportion of air to fuel by weight. To get a high power rich mixture is required. In fact to start the e

Imperfect frame - truss, Imperfect Frame - truss: Imperfec t Frame ...

Imperfect Frame - truss: Imperfec t Frame An Imperfect frame is one that does not satisfies relation between numbers of members and number of joints given by equation

What are methods used in rating for time study, a)What are methods used in ...

a)What are methods used in rating for time study. Illustrate them. b) Write down principles of motion economy.

Embrittlement-metallurgical defects, Embrittlement For use, at high str...

Embrittlement For use, at high strength, coupled with good notch toughness, all weld structure must  be Tempered low carbon martensite. Carbon and alloy steels having more than

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd