Cad - requirements for standard interface, Mechanical Engineering

Assignment Help:

Requirements for Standard Interface 

  • The interface must be capable of handling all kinds of manufacturing data.
  • There should be no information loss when data is transferred between heterogeneous systems. In other words, it must be possible to maintain the semantics during conversion.
  • The system must be capable of handling the real time requirements of a manufacturing system efficiently and effectively.
  • The system should be open-ended to permit extensions or contractions.
  • The system should be adaptable to other standards.
  • The system must be independent of the computer and communication architecture used.
  • The systems should be capable of handling maximum number of data entities. Ideally, there should not be any limitation.

 


Related Discussions:- Cad - requirements for standard interface

Calculate values of ki - thick cylinder, Calculate values of KI - thick cyl...

Calculate values of KI - thick cylinder: If cracks of 6 mm and 12 mm length are separately present only one side of inner surface in radial direction find two values of KI.

Explain the automation in machining, Explain the Automation in Machining? ...

Explain the Automation in Machining? The word "automatic" is derived from Greek and it means "self-moving or "self thinking". The word "automation" has been used to refer to a

Introduction service and maintenance procedures , INTRODUCTIO : In Motorc...

INTRODUCTIO : In Motorcycle Servicing, we studied about servicing of a motorcycle. Here, you will study about the detailed procedures for motorcycle service and maintenance. The s

Determine the fatigue strength of medium carbon steel, Determine the fatigu...

Determine the fatigue strength of medium carbon steel: For determining the fatigue strength of medium carbon steel 15 specimens, identical in all respect were tested in cantil

Breakwater , Let consider the breakwater configuration shown in the figure ...

Let consider the breakwater configuration shown in the figure below. The incident wave conditions at the breakwater are a wave height of 1.5m, wave period of 7.0s and a wave crest

Pressure at bottom of a cone, I have a tank that has a 30" dia at the top...

I have a tank that has a 30" dia at the top and is 24" deep. It connects to a cone that is 30" dia at the top and goes to a 15" dia in 12". I plan on filling the tank with golf ba

TMA 2, A temperature control process has a first-order response with a step...

A temperature control process has a first-order response with a step response time of 12 seconds. In selecting a temperature sensor for the control system for the process, for what

Thermodyamics, work is path function not a state function

work is path function not a state function

What uniformly distributed load per meter beam may carry?, Q. A rectangular...

Q. A rectangular beam which is 300 mm deep is simply supported over span of 5 m. What uniformly distributed load per meter beam may carry? If bending stress is not to exceed 130N/m

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd