Brick pavement, Civil Engineering

Assignment Help:

Brick Pavement:

In regions where stone aggregates are not available within economical leads, bricks provide a cheaper alternative. Flat-brick or brick-on-edge pavements provide a good sub- base.

Bricks can also be broken into ballast and used as aggregates for sub-base construction. The broken ballast is known as "jhama" metal. The bricks should be over-burnt to give best results.


Related Discussions:- Brick pavement

Surveying, sample problems with solutions for probable value

sample problems with solutions for probable value

Disparities b/w epoxy grout cement grout and cement mortar, Question What a...

Question What are the key disparities between epoxy grout cement grout and cement mortar ? Answer Epoxy grout contains of epoxy resin, epoxy hardener and sand or aggregates.

Illustrate bituminous surfacing over concrete structures, Q. Illustrate Bit...

Q. Illustrate Bituminous surfacing over concrete structures? Usage of bituminous surfacing over concrete structures (for instance existing concrete roads) is widespread to impr

Concrete mix proportions, Concrete Mix Proportions Concrete mix proport...

Concrete Mix Proportions Concrete mix proportions should be chosen in such a way that concrete of adequate workability is obtained. Workability of concrete mix should be such t

Determine the water content of the sand sample, In order to determine the w...

In order to determine the water content of a wet sand, a sample weighing 4 N was put in a pyknometer. Water  was then poured to fill it and the weight of the pyknometer and its con

Water bound macadam road, What is the binding material of the water bound m...

What is the binding material of the water bound macadam road

Solid mensuration, the two sides of a triangle are 17cm and 28 cm long, and...

the two sides of a triangle are 17cm and 28 cm long, and the length of the median drawn to the third side is equal to 19.5. find the distance from an endpoint of this median to the

Penetration test, Penetration Test: A viscosity is measured indirectl...

Penetration Test: A viscosity is measured indirectly by the penetration of a standard needle under standard conditions of load, time and temperature. The test measures the ha

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd