what does quality factor mean, Electrical Engineering

Assignment Help:

The Quality factor is also explained, as Q. So it is a number, which shows the lossness of a circuit. Higher the Q, the lower are the losses.

The quality factor is calculated of efficiency(or effectiveness) of a device or circuitry. In literal sense quality factor means qualitative performance of a device.       

 

 


Related Discussions:- what does quality factor mean

Explain telephone hand set and it’s working, Q. Explain Telephone hand set ...

Q. Explain Telephone hand set and it’s working ? A standard telephone set is comprised of a transmitter, a receiver and electrical network for equalization, associated circ

What is meant by blanking, a. Explain the following terms: (6) (i) Persi...

a. Explain the following terms: (6) (i) Persistence of vision (ii) Flicker in motion pictures b. What is meant by blanking? What is the need of blanking pulses? Compare th

What is microprocessor, What is Microprocessor? Give the power supply & clo...

What is Microprocessor? Give the power supply & clock frequency of 8085. A microprocessor is a multipurpose, programmable logic device that reads binary instructions from a sto

Make a plot of the signal, In order to demonstrate aliasing, make a plot of...

In order to demonstrate aliasing, make a plot of the signal x(t) = 3 cos 2π10t - cos 2π30t which approximates a square wave with W = 30 Hz. If the sample points are taken at

Find the highest speeds at which linkage would be possible, Q. Two coupled ...

Q. Two coupled synchronous machines are used as a motor-generator set to link a 25-Hz system to a 60-Hz system. Find the three highest speeds at which this linkage would be possibl

Determine the rectified load voltage, Consider the circuit of Figure (a) wi...

Consider the circuit of Figure (a) with v S (t) = 10 cos ωt. Use the piecewise-linear model of the diode with a threshold voltage of 0.6 V and a forward resistance of 0.5  to dete

Machine control instructions , Machine Control Instructions Instructio...

Machine Control Instructions Instructions used to control  various machine operations are kept  in this group.

The direction of motion, At what velocity must a conductor 75 mm long cut a...

At what velocity must a conductor 75 mm long cut a magnetic field of flux density 0.6 T if an e.m.f. of 9 V is to be induced in it? Suppose the conductor, the field and the directi

Determine the maximum value of the voltage, Q. Three waveforms seen on an o...

Q. Three waveforms seen on an oscilloscope are shown in Figure. If the horizontal scale is set to 50 ms per division (500 ms for the entire screen width), and the vertical scale is

Alternater, if the prime mover input of an alternater connected directly t...

if the prime mover input of an alternater connected directly to an infinite bus in increased,then its?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd