Write mass balance equation for the antibiotic in symbols

Assignment Help Civil Engineering
Reference no: EM13319152

Environmental engineers and scientists are becoming concerned about pharmaceuticals in the environment. An antibiotic is discharged into a small lake at an influent concentration of 0.05 mg/L. The lake has a surface area of 2 acres and a mean depth of 6 feet. The flow into the river is 200 cubic feet per second (cfs). The antibiotic is degraded naturally in the lake with a first-order rate constant of 0.002 s

A. What kind of hydrodynamic model should you use for a small lake?
B. Write the mass balance equation in words.
C. Write the mass balance equation for the antibiotic in symbols at steady state. Define your symbols.
D. What is the antibiotic concentration in a river draining the lake at steady state?

Reference no: EM13319152

Questions Cloud

How many moisture of aggregate will be needed : Base course aggregate has a target dry density 119.7 lb/cu ft in place. it will be laid down and compacted in a rectangular street repair area of 2000 ft x 48 ft x 6 in the aggregate in the stockpile contains 3.1% moisture.
Explain the rate of the reaction when it reaches equilibrium : The rate constant of the reaction: a. Depends on the concentration of reactants b. Describes the rate of the reaction when it reaches equilibrium c. Is a thermodynamic constant that is always true for a given reaction d.
What is the initial effect of the tax reduction : How does the total effect of this $20 billion tax cut compare to the total effect of a $20 billion increase in government purchases? Why?
What power should contact lenses have to allow the person : A farsighted person has a near point of 60.0 cm for the left ye and a near point of 90.0 cm for the right eye. What power should contact lenses have to allow the person
Write mass balance equation for the antibiotic in symbols : The lake has a surface area of 2 acres and a mean depth of 6 feet. The flow into the river is 200 cubic feet per second (cfs). The antibiotic is degraded naturally in the lake with a first-order rate constant of 0.002 s
What are the power of the objective of the telescope : An astronomical telescope uses an eyepiece of power +100.0 D. what are the power of the objective and the magnifcation of the telescope
Evaluate the ph of the resulting solution : A student adds 33.0045g of potassium acetate to water and then adds 7.0 ml of 1.0 M HCl to this . the resulting solution is diluted to 250.0 ml calculate the PH of the resulting solution.
Find the difference in conservation and conserving energy : to combat wasteful habits we often speak of "conserving engery", by which we mean turning off lights, find the difference in energy conservation and conserving energy
A slowdown in the economy increases unemployment : A slowdown in the economy increases unemployment and decreases output. As a result of this action, there will be an increase in the quantity supplied of loanable funds. an increase in supply the of loanable funds.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the ieee double precision floating number

Calculate the IEEE double precision floating number immediately greater than the minimum number in double precision in both binary and decimal form

  What is the elevation of lower point

A pre- engineering base line was run down a very steep hill.rather than measure horizontaily down hill with steel tape: surveyor measured the vertical angle with the theodolite and slope distance with 16m steel tape.

  How much water in cubic feet has been pumped out

The storativity of the Jordan Aquifer (a regional confined aquifer) is 5 x 10-4 and the porosity is 0.3. The thickness of the aquifer is 200 ft. The Jordan has been pumped for several decades, yet remains fully saturated.

  What is the total time spent in the system by all vehicles

Vehicles arrive at a toll bridge at a rate of 430 veh/hr (the time between arrivals is exponentially distributed) Two toll booths are open and each can process arrivals (collect tolls) at a mean rate of 10 seconds per vehicle

  Determine the magnitude of the resultant r and angle theta

Forces F and P have magnitudes of F=40 lb. and P= 60 lb., Using the paralellogram law, determine the magnitude of the resultant R and the angle theta it makes with the horizontal. The given angle is 40 degrees.

  Determine the prism constant with the measurements

To verify the constant of a particular prism, a straight line EFG is laid out. The EDM instrument is first set up at E, with the following measurements recorded: EG = 426.224 m, EF = 277.301 m.

  Determine the tension in cable be and the reactions a and d

A light bar AD is suspended from cableS and supports a 20 kg block at C. The extremities A and D of the bar are in contact with frictionless, vertical walls. Determine the tension in cable BE and the reactions A and D

  Determine what will be the max torque of a solid steel shaft

A solid steel shaft of circular cross section and diameter 6 inches in pure torsion under torque. If E=30x10^6 pse and max shear stress is 30 ksi, calculate the torque. If the shaft was hollow, with an innner diameter of 2 inches and outer diameter..

  Uva levels in raw and treated drinking water

My question is regarding UVA levels in raw and treated drinking water with regard to TOC and DOC removal. Is there a jar test procedure that incorporates the UVA values of the various stages of treatment and is there a document you could refer me ..

  Determine the length of pipe required at the linear velocity

A wastewater treatment plant must disinfect its effluent before discharging the wastewater to a near-by stream. The wastewater contains 4.5*105 fecal coliform colony-forming units (CFU) per liter.

  Highest point of the piping system

a) The maximum flow rate that can be achieved without cavitation occurring in the piping system. b) The maximum elevation of the highest point of the piping system to avoid cavitation.

  Determine the total dead load-per foot of length

Three-ply asphalt felt and gravel roof over 2in of insulation board is supported by 18in deep precast reinforced concrete beams with 3ft wide flanges. If insulation weights 3lb/ft 2 and the asphalt roofing weights 5.5lb/ft2, determine the total dea..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd