Would stainless screen have sufficient collapse strength

Assignment Help Civil Engineering
Reference no: EM13310474

A 5 inch (inside diameter) well is to be placed to a total depth of 60 m in an unconfined sand aquifer. The saturated unit weight (sat) of the sand is 20.0 kN/m3 and the anticipated depth to water in the well during pumping is 20 m below ground surface. Would a #30 slot stainless steel screen (2.0 m long; located at the bottom of the well) have sufficient collapse strength for this application?

Reference no: EM13310474

Questions Cloud

Determine principal stresses and the absolute shear stress : the stress at a point is shown on the element. Determine the principal stresses and the absolute maximum shear stress.
Explain the appropriate noble-gas core abbreviations : Write the condensed electron configurations for the following atoms, using the appropriate noble-gas core abbreviations. In order of increasing orbital energy. a) U b) Pb
State standard free energy of activation of another reaction : The standard free energy of activation of another reaction B is 78.70 kJ mol-1 (18.81 kcal mol-1). Assume a temperature of 298 K and 1 M concentration. By what factor is one reaction faster than the other. Which reaction is faster
How many acres in size would an aerated lagoon need : A small town produces 0.15 MGD of wastewater. How many acres in size would an aerated lagoon need to be to treat this wastewater assuming a depth of 8 ft. and a detention time of 6 days
Would stainless screen have sufficient collapse strength : The saturated unit weight (sat) of the sand is 20.0 kN/m3 and the anticipated depth to water in the well during pumping is 20 m below ground surface.
Determine what will be the cost of labor in dollars : Labor of this activity is given as in the CREW, 1 brick mason and 1 helper. The productivity is 0.5 labor hours per 1 sf. The wages are for the mason $60 and for the helper $45 per hour.
Explain half-life for the reaction at a given temperature : Butadiene can undergo the following reaction to form a dimer (two butadiene molecules hooked together). 2C4H8(g) > C8H12(g) The half-life for the reaction at a given temperature is 5.92*10^-2 sec
The least amount of culture-based discord : You are the human resources manager of a multinational corporation in Canada. Your corporation has recently established a subsidiary firm in Saudi Arabia, for which you have been assigned as the HR director.  Identify three policies/practices that yo..
Why the concentration is reduced at end of distribution pipe : The Fluoride feeder runs out of feed solution. The rapid mix tank is connected to a 5 km long distribution pipe. The flow rate into the tank mix tank is 0.44 m/s and the volume of the tank is 2.50 m.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Explain why the architects requires a deflection limitation

The buildings are single story with a rood line 6 feet above the man-door opening is constructed from clay brick that is 12 inches thick and weighs 115 psf. the opening of the man-doors are 3 feet 4 inches wide.

  Heat exchanger second-law efficiency

The condenser in a refrigerator receives R-134a at 700 kPa and 50C, and it exits as saturated liquid at 25 C, The flow rate is 0.1 kg/s,and the condenser has air in at an ambient temperature of 15 C and leaving at 35 C. Find the minimum flow rate ..

  Would calcite be over or under-saturated in hot water heater

If log KSO, calcite (CaCO3(s)) = -8.61 at 50 oC, would calcite be over- or under- saturated in a hot water heater at 50 oC if the water was in equilibrium with calcite at 25 oC (log KSO = -8.30) when it entered the house

  Complete max demand calculation for fully ac hospital

Complete a maximum demand calculation for a fully air conditioned hospital with the following electrical equipment and outlets.  500, 28W lamps  200, 14W lamps 400, 10A socket outlets 5, 18A, 3 phase, air conditioning units

  Give short explanation on principal behind how gauge works

Draw a picture of a typical strain gauge and point out the major components. Give a short explanation on the principal behind how a strain gauge works.

  Transportation and management

In the construction management, there is a lot of procurement route that are necessary and suitable for the construction industry.

  What ration of lengths will cause the maximum shear stress

A solid circular shaft AC of total length L=L1+L2 is fixed against rotation at ends A and C and is loaded by a tourqe T_b at joint B. If the diameter of the two segements of the shaft are in ratio d2/d1

  What is the cumulative depreciation through the end of year

Under the 200% DB depreciation, what is the cumulative depreciation through the end of year four? The useful life of the mixing tank is 9.5 years.

  How to design a cyclone that has a collection efficiency

Design a cyclone that has a collection efficiency between 80% and 85% (use parcticle size distribution given below). you must assume a dpc of 4.2 microns,an inlet gas velocity of 25 m/s and a K of 15.

  Determine the saturated hydraulic conductivity of the layer

This uniformly reduces 4X10-4 cm / s to a depth of 22 meters. If the water level is about 3 feet below the surface, determine the saturated hydraulic conductivity of the layer.

  What additional information would need to calculate stress

The bar under the applied force is now 2.448 meters long. Calculate the following for the bar: a) engineering stress, b) engineering strain, c) true strain, d) Young's modulus, e) What additional information would you need to calculate the true st..

  Determine the compound empirical and molecular formula

A Silane contains 90.31 % silicon and 9.69 % hydrogen by mass. The compound has a molar mass of 62 g/mol. Determine the compound's empirical and molecular formula.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd