Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A concrete mix with a 3 inch slump, w/c ratio of 0.50, and sand with a fineness modulus of 2.4 contains 1.700 lb/yd^3 of coarse aggregate. Compute the required weight of coarse aggregate per cubic yard. to adjust the mix so as to increase the compressive strength, the water-to-cement ratio is reduced to 0.45. will the quantity of coarse aggregate increase, decrease, or stat the same?
The forward direction is given by the alphabeteical order of the station names. Each angle is measured clockwise from the back direction to the forward direction so that they are on the left of the traverse looking forward.
An air-water vapor mixture at 0.1 MPa, 35 C and 70% relative humidity occupies a volume of 100 m^3 Determine the humidity ratio, the dew point, the mass of dry air in the volume and the mass of water vapor in the volume.
What does under-reinforced mean Which is desirable and why How would your Moment-Curvature plot be affected if the amount of tension steel was doubled How would your Moment-Curvature plot from part a be affected if compression steel was added to the..
Write a MATLAB code that calculates the weight (forces due to gravity) in lbf on each planet of our solar system and earth's moon for probes/rovers which have a mass between 100 lbm and 300 lbm. Use increments of 20 lbm.
A concrete building has floor area 10 m by 20 m and is 4 m high. THe building has four windows with a height 1.6 m and a width 2 m. After 10 minutes gases in the room have an average temperature of 700 degree Celcius.
If the aircraft flies at 9000 m standard altitude, make a plot of drag (in N) versus speed (from stall to 240 m/s) and determine the optimum emise velocity (minimum drag per unit speed).
Two tests are taken from the compacted mixture and checked for density. Core 1 had a density of 150 pcf and an air void content of 6.5 %. Core 2 had a density of 151 pcf. What is the air void content of core 2
A motorists inflates the tires of her car to a gauge pressure of 180 kilopascals on a day when the temperature is -8.0 degrees Celsius. When she arrives at her destination, the tire gauge pressure has increased to 245 kilopascals.
The wastewater treatment plant for Pine City discharges 1 × 105 m3/day of treated waste to the Pine River. Immediately upstream of the treatment plant, the Pine River has an ultimate CBOD of 2 mg/L and a flow of 9 × 105 m3/day.
On a very hot day, I saw a 1.6 meter long steel bar held between two rigid supports that had buckled due to the heat. The bar had a cross section of 10 mm by 40 mm, and I assume was A36 steel.
A two stage crushing operation feeds 0.6 m diameter ore into a primary crusher at a rate of 25mt/hr. 80% of the ore feeds through an 0.2m screen into a secondary crusher. 65% of the ore from the secondary crusher comes out of a 50mm screen.
A 3000 lb vehicle has a drag coefficient of 0.32 and a frontal area of 30 ft2. What is the minimum tractive effort required for this vehicle to maintain a 65 mph speed on a 2% upgrade through an air density of 0.002045 slugs/ft3
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd