When the local mean time at los angeles

Assignment Help Civil Engineering
Reference no: EM13544591

1.When the altitude of the lower edge of the sun was observed with a transit on July 3, the reading of the vertical limb was 26degrees 20' 30". If the index error was +1’00”, the true altitude of the sun’s center was

(a) 26 degrees 01' 57"

(b) 26 degrees 03' 57"

(c) 26 degrees 33' 29"

(d) 26 degrees 35' 29"

2.The longitude of Albany, New York, is +73 degrees 44' 49" and the longitude of Los Angeles, California, is +118 degrees 10' 44". When the local mean time at Los Angeles is 10h 41m 00s a.m., the local mean time at Albany is

(a) 7h 41m 00s a.m.

(b)7h 43m 16s a.m.

(c) 1h 38m 44s p.m.

(d) 1h 41m 00s p.m.

3.When the sun was observed for azimuth at a place in latitude 37 degrees 23 feet 12 inches, the ture altitude of the sun’s center was 45 degrees 38 feet and the declination of the sun was S 9 degrees 15.8 feet. The value of ½ (z +l-d) was:

(a) 36 degrees 14 feet 42 inches

(b) 36 degrees 52 feet 42 inches

(c) 45 degrees 30 feet 30 inches

(d) 46 degrees 08 feet 30 inches

Reference no: EM13544591

Questions Cloud

Estimate the amount of coal needed to light one 100-w : A 25-W compact fluorescent lightbulb (CFL) produces the light equivalent of a 100-W incandescent bulb. The population of North America is estimated to be about 305 million. Estimate the amount of coal needed to light one 100-W incandescent lightbulb
Calculate the hydraulic conductivity of silica sand : A constant-head permeability test was conducted on a sample of fine silica sand. The cross-sectional area of the sample was 60 cm2 and its length was 150 mm.
Calculate the horizontal scale factor and effective : The foundation soil for an earth dam has a horizontal hydraulic conductivity of 1.5 x 10-9 m/s and a vertical hydraulic conductivity of 1 x 10-10 m/s. It is proposed to estimate the seepage flow rate through the foundation soil using the flow net ske..
Determine the maximum tensile and compression stresses in : A 6ft wide, 10ft high vertical rectangular gate has its top edge 6ft below the water level. it is hinged along its lower edge. what force, acting on the top edge, is necessary to hold the gate shut?
When the local mean time at los angeles : The longitude of Albany, New York, is +73 degrees 44' 49" and the longitude of Los Angeles, California, is +118 degrees 10' 44". When the local mean time at Los Angeles is 10h 41m 00s a.m., the local mean time at Albany is
Calculate the height of water in the standpipe after 4 hours : A falling-head permeability test is being conducted on a saturated sample of clayey silt having hydraulic conductivity of 6.5 x 10-9 m/s. The diameter and the length of the sample are 100 mm and 150 mm
Determine the volume flow rate per unit width and the shear : Determine the volume flow rate per unit width amd tje shear stress of the upper plate (Start with the full, three-dimensional Navier-Stokes equations and the continuity equation, simplify them, and then solve them
How large must the sample be if we wish to be at least : How large must the sample be if we wish to be at least 95% confident that the error in estimating p is less than 0.02, regardless of the true value of p?
What is the temperature of the small vessel at the end of : A small nitrogen container is at Pressure P1 = 5 bar and T1 = 300 K. It's been filled from a larger nitrogen container, which is P= 10 bar and T = 300 K. The filling process ends when pressure in the small container

Reviews

Write a Review

Civil Engineering Questions & Answers

  Write the mass balance equation for a plug flow

Write the mass balance equation for a plug flow with a second order decaying substance,C. Solve for the steady state concentration of C as a function of the second order rate constant k, longitudinal distance x, mean velocity u, and the concentrat..

  Cd triaxial compression test

CD triaxial compression test the specimen was consolidated under an effective confining stress

  What is the required detention time and tank volume

A chlorination process is to be used to disinfect a wastewater treatment plant effluent. The plant treats 1.8MGD (million gallon per day). The water entering this unit has about 4500mg/L of coliforms, and the effluent target is 0.1 mg/L of coliforms.

  Determine the maximum compression of the spring

The 30-Mg freight car A and 15-Mg freight car B are moving toward each other with the velocities VA= 20 km/h to the right and VB= 10 km/h to the left. the spring constant on car A is k= 3MN/m.

  Determine the self weight moment of inertia

Determine the self weight, moment of inertia, and cross-sectional areas for the following hot rolled standard section:

  Calculate the velocity of air at the entry in ft per second

A compressor pressurizes air from 1 atm to 2.38 atm at steady state. At the entry the air's temperature is 70F, whereas at the exit it has quadrupled (in degrees F). At the entry the air's volumetric flow rate is 17 ft3/s

  Determine the aadt for the axle counts 28000 axles have

1 determine the design hourly volume for the road below recommend the k factor first.a. for a two lane highway in a

  Over what distance does discharge increase in depth occur

In a short section of a channel carrying a steady discharge of 36 m^3/s, the depth is seen to increase from 1.6 m to 1.75 m. The channel is rectangular, 20 m wide with a bedslope of 0.0002 and Manning n of 0.014.

  Determine the force at the circular endcap of the pipe

Determine the force at the circular endcap and its location relative to the bottom of the pipe. If there is a hinge at the bottom, what external force would need to be applied to the top to prevent rotation

  Determine the maximum acceleration from rest

A rear-wheel-drive car 2600 lb, has an 80-inch wheelbase, a center of gravity 20 inches above the road surface and 30 inches behind the front axle, a drivetrain efficiency of 85%, 14-inch-radius wheels,

  Determine the time needed to begin lifting the crate

If the 20-kg crate is originally resting on the floor such that the cable tension is zero at the instant the motor is turned on, determine the speed of the crate when t=6s.

  Determine the exit temperature if the gas is argon helium

Deteemine the velocity of the 30 kg block A if the two blocks are released from rest and the 20 kg block B Moves 0.6 mup the incline .The coefficient of kinetic friction between both blocks and the inclined planes is 0.10

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd