Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Assume you are an observer standing at a point along a three-lane roadway. All vehicles in lane 1 are travelling at 30 mi/h, all vehicles in lane 2 are travelling at 45 mi/h, and all vehicles in lane 3 are travelling at 60 mi/h. There is also a constant spacing of .5 mile between vehicles. If you collect spot speed data for all vehicles as they cross your observation point, for 30 minutes, what will be the time-mean speed and space-mean speed for this traffic stream?
A tied short column of square cross-section is subjected to a factored axial load of 2500 kN and a factored bending moment of 175 kN.m. Use a 40 mm clear cover to the ties and a 20 mm maximum aggregate size.
If e is some value at midspan and e=0 at each end of the beam, and the cable within the beam has a parabolic profile. what is the expression I need to use to determine e at some other lenth along the beam
It is known that the velocity distribution for steady, laminar flowin circular tubes (either horizontal od vertical) isparabolic. Consider a 10 -mm- diameter horizontal tubethrough with ethyl alcohol is flowing with a steady mean velocity.15 m/s.
a) What was the discharge capacity andvelocity at full flow at the time of installation b) If the pipe presently carries a flow of15 cfs when full, determine the present velocity and present value of n.
the path of particle p ios the elipse difined by relations r=2/(2-cosPIEt) and theta=PIEt, where r is exspressed in meters , tis in seconds nd thet is in radians. Determine the velocity and the acceleration of the particle whern t=0 seconds
The brass tube AB (E=105 GPa) has a cross-sectional area of 140 mm^2 and is fitted with a plug at A. The tube is attached at B to a rigid plate that is itself attached at C to the bottom of an aluminum cylinder
Air enters an electrical furnace at 20oC, 100 kPa, with a volumetric flow rate of 30 m3/min. The furnace delivers air at 40oC to a duct system with three branches consisting of two 15-cm-diameter ducts and a 30-cm-diameter duct.
Given the EPA acceptable risk level of 1 cancer in a million, what is the maximum concentration of TCE you can tolerate at the dry cleaning facility and keep your incremental cancer risk below the acceptable risk
What is the porosity of a sphere of 1 ft diameter packed inside a cube of 1 ft on each edge. What if the spheres are six inches in diameter. What if the spheres are one inch in diameter.
Sketch a streamline, pathline, and streakline, For a given flow the velocity from time t=0 to t=5s was u=2 m/s, v=0. Then from t=5s to t=10s the velocity was u=+3 m/s, v=-4 m/s. A dye streak was started at t=0
The coal may either be moved by train from the mine to power plants near where the power is used, or the coal could be combusted near the mine mouth to generate electricity and the electricity could be transmitted over long distances to the users.
The air density is 0.00206 slugs/cuft. The car has frontal area of 19.8 sqft, a drag coefficient of 0.28, a wheel radius of 12.6 inches, a drive axle slippage of 3%, and a drivetrain efficiency of 88%.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd