User Account

All Pages

What will be potential difference between plates seperation

Assignment Help Electrical Engineering
Reference no: EM13228098

An Air capacitor consisting of two closely spaced parallel plates has a capacitance of 1000 pF. The charge on each plate is 1 micro C. What is the potential difference between the plates. If the charge is kept constant what will be the potential difference between the plates if the seperation is doubled. How much work is required to double the seperation.

Reference no: EM13228098

Questions Cloud

Determine whether the system is stable or not : A system has a characteristic equation: q(s) = s3 + 20s2 + 5s + 100 = 0 Determine whether the system is stable using the Routh-Hurwitz criterion. Determine the roots of the characteristic equation.
Explain barium nitrate and observe again : Observe while adding 0.5 mL of 6M HCl to 1 mL samples of the anion solutions and then add 5 drops of 0.1M barium nitrate and observe again.
What two points associated with the load line : Discuss the steps required in calculating the collector-emitter voltage in a VDB circuit. Why does this circuit have a very stable Q point Discuss whether transistors being used as switching circuits should be biased in the active region.
Explain reaction is not spontaneous at any temperature : The following reaction is not spontaneous at any temperature. Which applies to the system at 298 K? 2C(s) + 3H2(g) --> C2H6(g)
What will be potential difference between plates seperation : An Air capacitor consisting of two closely spaced parallel plates has a capacitance of 1000 pF. The charge on each plate is 1 micro C. What is the potential difference between the plates. If the charge is kept constant.
Explain a concentration of the pollutant no2 in air : A concentration of the pollutant NO2 in air of 3.00 ppm (m/v) may be lethal to humans. Will air that contains 1.9 x 10^-3g at NO2 per liter be lethal to humans?
Explain how many grams of hcl will be produced : How many grams of Hcl will be produced from the reaction of 50.0mL of a 0.300M CaCl2 according to the reaction:CaCl2 + H3PO4(aq) ----> Ca3(PO4)2 (s) + HCl (aq)
How to implement the power factor correction scheme : A 60-Hz source supplies power to an industrial load through a transmission line of impedance (0.2+ j0.1) ohms. The load consumes 130 kW of power at line voltage VL= 440
Determine the source voltage of power transmission system : Determine the source voltage Vs of a 60-Hz power transmission system from the loading conditions described as follows: 1. The load is capacitive and absorbs 12 kW at 240

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define in words how the display on the spectrum

The waveform output by the signal generator in part (b) is changed so that the rectangular pulses have the same width but no longer are periodic. They occur at random intervals of time. Explain in words how the display on the spectrum screen would..

  How to adjust the inductance in an lc oscillator

The tuning control is required to provide a uniform, linear change in frequency for a fixed rotation of the knob, e.g., 25 kHz per revolution at any operating frequency.  You are considering three options for controlling the frequency

  Calculate the phase currents and the line currents

A three-phase, 400 V system has the following load connected in delta: between the red and yellow lines, a non-reactive resistor of 100; between the yellow and blue lines, a coil having a reactance of 60 and negligible resistance

  Calculate the mmf when the machine operates

calculate the mmf when the machine operates at rated voltage at full load? PLease explain how to get the solution to this problem?

  Define the gain of the antennas must be increased

The gain of the antennas must be increased when the TDMA system described in part (d) is used because the bit rate is higher than with FDMA and the noise power in the receiver is therefore higher

  Determine the concentration of donor impurity atoms

A silicon sample at T = 300 K contains an acceptor impurity concentration of \(N_{A}\) = 1016 cm-3. Determine the concentration of donor impurity atoms that must be added so that the silicon is n-type and the Fermi energy is 0.20 eV

  Write down the principle of energy conversion

Write down the principle of energy conversion and give an example for single and double excited system.

  How high can vce go without exceeding

A certain transistor is to be operated at a collector current of 50mA. How high can VCE go without exceeding a PD(MAX) of 1.2W?

  Determine what is the order of the system

Compute y(nT) iteratively for n=0, 1, 2, when, y(-T)=2, and x(nT) = u(n) Hint: the initial conditions are given for negative n. Shift the equation to the right to express x() and y() to eliminate all advances and end up with x(n), y(n)

  Estimate the diffusivity of a spherically shaped protein

Estimate the diffusivity of a spherically shaped protein with a MW of 36,000 in water at 37oC.

  What is the range of the sensor voltage outputs

A manufacturer specification sheet lists the transfer function of a pressure sensor as 45±5% mV/kPa with a time constant of 4±10%. A highly accurate test system applies a step change of pressure from 20 kPa to 100 kPa.

  Sketch the capacitance-voltage characteristics

Sketch the Capacitance-Voltage characteristics for both devices based on part (d) by giving appropriate labeling to the voltage and capacitance axis. You may assume high f measurements.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd