What should the volume of each reactor be to produce an

Assignment Help Civil Engineering
Reference no: EM13559099

The removal of a volatile organic compound (VOC) from a wastewater can be described by a first order reaction with a reaction rate constant of 5 day-1. The wastewater has a flow rate of 150 m3/hr, and is treated in a series of two completely mixed flow reactors which each have an equal volume. If the influent VOC concentration is 10 mg/L, what should the volume of each reactor be to produce an effluent concentration of 0.1 mg/L?

Reference no: EM13559099

Questions Cloud

Describes and evaluates apple organization innovation : Describes and evaluates APPLE organization's innovation strategy
How much can the company afford to spend now if its minimum : Wheeling-Pittsburgh Steel is investigating whether it should it should replace some of the basic oxygen furnace equipment now or wait to do it later. The cost later (i.e. 3 years from now) is estimated to be $1,700,000.
Evaluate what is the angular speed of the ball : A soccer ball whose radius is 11 cm rolls a distance of 10 min 3.50 s. It rolls without slipping. What is the angular speed of the ball
What is the equivalent uniform cost per semiannual period : Heyden Motion Solutions ordered $7 million worth of seamless tubes for its drill collars from the Timken Company of Canton, Ohio. (A drill collar is heavy tubular connection between a drill pipe and a drill bit.) At 12% per year
What should the volume of each reactor be to produce an : The removal of a volatile organic compound (VOC) from a wastewater can be described by a first order reaction with a reaction rate constant of 5 day-1. The wastewater has a flow rate of 150 m3/hr
How many liters of biosolids can be applied to an acre : The Biosolids from a wastewater treatment process contains 1 mg cadmium per Kg of dry solids. The biosolids from the plant contain 23% solids and have a specific gravity of 1.01. If the state department of environmental quality has
What shear stresses exist at mid depth : A rectangular beam of width 300 mm and depth 450 mm supports loads producing a shear force of 300 kN at a particular section. What shear stresses exist at the following points?
What is the grating spacing of the beetle : Perhaps to confuse a predator, some tropical beetles are colored byoptical interference that is due to scales whose alignment forms adiffraction grating, What is the grating spacing of the beetle
Company impact upon its society and stakeholders : How well does the company impact upon its society and stakeholders

Reviews

Write a Review

Civil Engineering Questions & Answers

  Why are viruses difficult to remove from water supply system

Compare the relative contributions of a treated water supply and the collection, treatment and disposal of human wastes towards the control of epidemic diseases in developing countries.

  Determine min volume of concrete needed to keep the gate

Determine the minimum volume of concrete needed to keep the gate(1m wide) in a closed position, with l=2m. Note the hinge at the bottom of the gate

  What is the volume of the lake in cubic feet

A shallow lake can be considered a CFSTR. Nitrification, the conversion of ammonia to nitrate (NH3 -> NO3-) occurs in the lake according to first – order kinetics. One stream feeds the lake and one stream empties the lake with the flow rate in both b..

  What air pressure in psig is needed to raise the maximum

Assume the lubricating fluid is changed to oil with a dynamic viscosity of 1.4X10E-3 lbf-s/ft^2. Now what air pressure, in psig, is required to overcome shear force ? Use the same lift rate of 0.1 ft/sec.

  Determine the magnitude of the acceleration of point p

A wheel has an angular acceleration of alpha=(0.5*theta) rad/s^2 , where theta is in radians. a) Determine the magnitude of the velocity of point P located on its rim after the wheel has rotated 2 revolutions.

  Determine the increase in internal energy of the system

The only work interaction between the system and the surroundings is via the paddle wheel. The work done on the system via the paddle wheel is 220 ft*Ibf and the heat interaction can be assumed negligible.

  Find the tensions in both sides of the rope for someone walk

You are given that a piece of rope is 90.5 ft long. The distance between the poles holding the rope is 90 ft. We are to find the tensions in both sides of the rope for someone walking across the rope and the deflection

  Explain how to present the geological profile of the terrain

Based on information provided in the survey bulletins and knowing that the landfill is located in the municipality of Duque de Caxias, on the shore of Guanabara Bay opposite Governor's Island (Galeao Airport)

  Determine vertical stress increment due to the strip load

Soil with a unit weight of 19.65 kN/m^3 is loaded on the ground surface by a strip load of 1.5 m wide. The strip load is 365 kN/m of wall length. Determine the vertical stress increment due to the strip load and the total pressure

  Estimate the final ph and the final tds of the mixture

It has been proposed to mix a 1500 L bath containing 5% by volume of H2SO4 with a 1500 L bath containing 5% by weight of NaOH. The Specific gravity of the acid added is 1.841 and its purity is 96%.

  What is the maximum length of trench that can be excavated

What is the maximum length of trench that can be excavated by hand economically rather than by a trenching machine. It will cost $900.00 to transport a trenching machine to the job and back to the storage yard.

  Compose a list here of the geological terms

Was the dam itself of sound design and a product of quality construction?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd