What is the stress in the copper cube

Assignment Help Physics
Reference no: EM13319444

A cube of copper with each edge having the dimension 12.7 mm, is put in a vise and squeezed by a force of 215 N exerted by either side of the vise.

(a) What is the stress in the copper cube?

(b) What is the strain in the copper cube?

(c) By how much does the side of the copper cube decrease?

(d) How would your answers change for a smaller copper cube that has half the edge length of 6.35 mm?

Reference no: EM13319444

Questions Cloud

One of the scarce resources that constrain our behavior is : How do you go about weighing the alternatives? Once you choose a most important use of time, why do you not spend all your time on it? Use the notion of opportunity cost in your answer.
Calculate the hi and the elevation of point x : If a plus sight of 1.097 m is taken on BM A, elevation 312.547 m, and a minus sight of 0.832 m is read on point x, calculate the HI and the elevation of point x.
What is the angular acceleration of the rod : A rod of length l and uniform mass m is hinged at its lower end while it was held at rest in a vertical position. What is the angular acceleration of the rod during the fall for a given theta
Determine stress in member immediately after load is applied : You are analyzing a polymer uniaxial tension member used in a lightweight structure. The bottom of the tension member is fixed and the top has a tensile force F = 10,000 pounds on it.
What is the stress in the copper cube : A cube of copper with each edge having the dimension 12.7 mm, is put in a vise and squeezed by a force of 215 N exerted by either side of the vise. What is the stress in the copper cube
A decrease in aggregate supply, with no change in aggregate : Assume that (a) the price level is flexible upward but not downward and (b) the economy is currently operating at its full-employment output. Other things equal,how will each of the following affect the equilibrium price level and equilibrium level o..
Compute the ph at the points in the titration : Calculate the pH at the points in the titration of 40.00 mL of 0.425 M NH3 for the reaction below. NH3(aq) + HNO3? NH4+(aq) + NO3?(aq) For NH3, Kb = 1.8x10-5. Enter your answer with 2 decimal places. Enter scientific notation as 1.23E4.
Determine the tension in each of the cables at a time : A long trough is supported by a hinge along its lower edge and a series of horizontal cables attached to its upper edge. Determine the tension in each of the cables, at a time when the trough is full of water.
With what minimum speed must he drive off horizontal ramp : A stunt driver wants to make his car jump over 8 cars parked side by side below a horizontal ramp as seen in the figure below. With what minimum speed must he drive off the horizontal ramp to just barely make it across

Reviews

Write a Review

Physics Questions & Answers

  What fraction of the heat leaving the burned gases

An ideally efficient airplane engine provides work as heat flows from 1400 K burned gases to 260 K air

  Determine how far are you from the pole

If you hold a 400 cm^2 square plane mirror 43cm from your eyes and can just see the full length of an 8.1m falgpole behind you

  Produce a dark fringe at the identical location on screen

If a car traveling at 66 km/h will skid 22 m when its brakes lock, how far would it skid if it is traveling at 120 km/h when its brakes lock.

  Find the velocity of the water coming out of the hole

You have a cylindrical cup of water that springs a leak 5 cm below the surface of the water. What is the velocity of the water coming out of the hole

  What would be block speed at that point

A block of mass 0.570 kg is pushed against a horizontal spring of negligible mass until the spring is compressed a distance x. The force constant of the spring is 450 N/m.

  Find the force to keep object moving

Find the force to keep object moving.

  Compute the total heat flow into the gas

An ideal gas expands at a constant pressure of 2.1 atm from 446 mL to 844 mL. Heat then flows out of the gas, What is the total heat flow into the gas

  What is the electric field on the axis of the washer

A thin, flat washer is a disk with an outer diameter of 14 cm and a hole in the center with a diameter of 3 cm. What is the electric field on the axis of the washer

  Define time constant for charging the capacitor

Please helps me out for determining the following if the capacitor in the circuit below is initially uncharged.

  What will be its kinetic energy when it hits the ground

Suppose you throw a 0.048-kg ball with a speed of 10.7 m/s and at an angle of 32.1° above the horizontal from a building 11.5 m high. What will be its kinetic energy when it hits the ground

  How far does earth move toward her as she falls

Your friend's mass is 70 .If she jumps off a 120--high table, how far does Earth move toward her as she falls

  How many joules of energy are used by the flashlight

You have a flashlight that uses 0.75 watts of power and requires 1.5 volt battery, How many joules of energy are used by the flashlight in 15 minutes

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd