What is the overall bandwidth of this arrangement

Assignment Help Electrical Engineering
Reference no: EM131226952

A direct-coupled (dc) amplifier (one whose response extends down to zero frequency) has an upper 3 dB frequency of 100 kHz. What is its bandwidth? When coupled to a signal source using a capacitor, its frequency response is found to deteriorate at low frequencies, the response being reduced by 3 dB at 20 kHz. What is the overall bandwidth of this arrangement?

Reference no: EM131226952

Questions Cloud

Determine the low frequency and high frequency cutoff values : Use a computer simulation to plot the small-signal voltage gain versus frequency.- Determine the low-frequency and high-frequency cutoff values.
Gives the appropriate information in the cells for article : You may use the "Empirical Research Checklist" to determine if a study is empirical. Provide the appropriate information in the cells for the Article 1 and Article 2 columns of the "Comparison Matrix."
Describe policy issue for your selected role specialization : Describe a policy issue for your selected role specialization. Synthesize knowledge for values theory, ethics, and legal regulatory statutes, and develop a personal philosophy that will map out a policy strategy that uses a high degree of politica..
What is the magnitude and phase : For the amplifier transmission, what is the magnitude? What is the phase?
What is the overall bandwidth of this arrangement : When coupled to a signal source using a capacitor, its frequency response is found to deteriorate at low frequencies, the response being reduced by 3 dB at 20 kHz. What is the overall bandwidth of this arrangement?
What advice do you have for her : She wants to get as many shares in the IPO as possible and would even be willing to buy the shares in the open market immediately after the issue. What advice do you have for her?
Explore historical evolution of the advance practice nurse : Analyze attributes of the practice arena such as access and availability, degree of consumer choice, competition, and financing that impact advanced practice nurses and their ability to effectively collaborate with other health professionals.
Plot the loop gain as a function of frequency : Consider the circuit shown in given Figure(a). - Using a computer simulation, plot the loop gain as a function of frequency.
What is the type of the corresponding output v : Consider the circuits of Fig. 1.22 (on page 31 of the Text). In a particular system application, a new out-put V, = - V, is created in each case. What is the type of the corresponding output V for circuit a)? circuit b)?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find expressions for the current-power and stored energy

The voltage across a 1-µF capacitor is given by v(t)=100 e-100t . Find expressions for the current, power, and stored energy. Sketch the waveforms to scale versus time.

  Calculate the line currents and the neutral current

Calculate the line currents and the neutral current.

  Find the internal resistance of the dc power suppy

A 50 V DC power supply is connected to a 100 Ohm load resistor. The tested current flowing through the resistor is 0.49 A. find the internal resistance of the DC power suppy.

  Calculate the normal strain and elongation of the plate

A square plate of titanium is 12cm along the top, 12cm on the right side, and 5mm thick. A normal tensile force of 15kN is applied to the top side of the plate. A normal tensile force of 20kN is applied to the right side of the plate.

  Calculate the powers p1 and p2 dissipated across r1 and r2

A battery E (e.m.f 12v and internal resistance 0.8 ohms) and a resistor R1 (10 ohms) are connected in series across two parallel resistors (R2 = 12 ohms, R3 = 18 ohms). i) Draw the circuit diagram, determine the battery terminal voltage.

  What is the value of voltage across on phase of the loadbank

The line voltage and current delivered to a balanced 3-phaseWye- connected resistive load bank is measured and found tobe 415 V and 30 A respectively. 1) What is the value of voltage across on phase of the loadbank

  Determine the entropy of the source.

A source consists of six outputs denoted [A; B;C; D; E; F] with respective probabilities [0:25; 0:25; 0:2; 0:1; 0:1; 0:1]. Determine the entropy of the source.

  To what value should the 2 a source be changed to reduce vx

(a) Using superposition, determine the voltage labeled vx in the circuit represented. (b) To what value should the 2 A source be changed to reduce vx by 10% (c) Verify your answers by performing three dc sweeps in PSpice.

  Does this induced current run clockwise or counterclockwise

Give a counterexample to show that the following statement is false: "When the magnetic field through a loop changes, currents run in the loop in such a way as to make a new magnetic field in the opposite direction to the original one."

  Find the total real and reactive power delivered to load

A 345-kV, 3-phase transmission line delivers 100 MVA, 0.866 lagging, to a wye connected load. Calculate the following: a. The total real and reactive power delivered to the load. b. The real and reactive power per phase.

  Find percentage increase in available current for starting

A standard 12-V car battery has an ampere-hour rating of of 30 Ah, whereas a heavy-duty battery has a rating of 51 Ah.  the ratio of available energy is 1.7 ratio.  Find the percentage increase in available current for starting

  Design a second-order band-pass iir filter with centre freq

Design a second-order band-pass IIR filter with center frequency of 450 Hz when the sampling frequency is 2,000 Hz. In order to ensure the filter stability, set the poles at 0.96 radial distant from the origin

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd