What is the magnitude and phase

Assignment Help Electrical Engineering
Reference no: EM131226953

In passing through a particular amplifier, an input sinc wave of 2 mV peak-to-peak amplitude at I kHz emerges with the same wave shape, an amplitude increased to 2V peak, and evidence that is has been delayed by 0.2 ms. For the amplifier transmission, what is the magnitude? What is the phase?

Reference no: EM131226953

Questions Cloud

What was the value of ending inventory : a. What was the gross profit? (Do not round intermediate calculations.) b. What was the value of ending inventory? (Do not round intermediate calculations.)
Determine the low frequency and high frequency cutoff values : Use a computer simulation to plot the small-signal voltage gain versus frequency.- Determine the low-frequency and high-frequency cutoff values.
Gives the appropriate information in the cells for article : You may use the "Empirical Research Checklist" to determine if a study is empirical. Provide the appropriate information in the cells for the Article 1 and Article 2 columns of the "Comparison Matrix."
Describe policy issue for your selected role specialization : Describe a policy issue for your selected role specialization. Synthesize knowledge for values theory, ethics, and legal regulatory statutes, and develop a personal philosophy that will map out a policy strategy that uses a high degree of politica..
What is the magnitude and phase : For the amplifier transmission, what is the magnitude? What is the phase?
What is the overall bandwidth of this arrangement : When coupled to a signal source using a capacitor, its frequency response is found to deteriorate at low frequencies, the response being reduced by 3 dB at 20 kHz. What is the overall bandwidth of this arrangement?
What advice do you have for her : She wants to get as many shares in the IPO as possible and would even be willing to buy the shares in the open market immediately after the issue. What advice do you have for her?
Explore historical evolution of the advance practice nurse : Analyze attributes of the practice arena such as access and availability, degree of consumer choice, competition, and financing that impact advanced practice nurses and their ability to effectively collaborate with other health professionals.
Plot the loop gain as a function of frequency : Consider the circuit shown in given Figure(a). - Using a computer simulation, plot the loop gain as a function of frequency.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Prove corresponding rule for four-vectors and four-tensors

State and prove the correspornding rule for four-vectors and four-tensors

  How long does it takc for the output to reach 0 v

A Miller integrator for which the time constant is 1 ins is driven by a positive step of 1 volt amplitude. What does the output do? At what rate? If the initial output voltage is 10 V. how long does it takc for the output to reach 0 V?

  Design a system that has an output of 1 when the input

design a system that has an output of 1 when the input has been 0 for exactly 7 clock times first by using a 4 bit

  Design rectifier circuit and use result to turn on led

design and build a rectifier circuit and use its result toturn on led( Use 60 Hz, 0.5 to 2 volts peak as a source, setupamplification circuit if needed to turn on led. use transistor todrive led., and also write concluson and explain the analysis.

  Find the current through each resistor

Resistors of R1= 10Ω, R2 = 4Ω and  R3 = 8Ω are connected up to two batteries (of negligible resistance) as shown. Find the current through each resistor.

  What will be the output of the adc in binary form

An embedded system with a 8 bit analog to digital converter is connected to a transducer with an output voltage of 20 millivolts. This signal is then amplified by an amplifier with a gain of 50. Assume that this signal level is appropriate for the..

  Sketch the output voltage and output current waveform

A single phase cyclo - converter with mid point configuration is use for obtaining an output frequency of one third times the inputfrequency. Turn ratio from primary to upper secondary is 1/1 and tolower secondary is 1/2 .

  Estimate the starting concentration of impurity

A limited source diffusion is used to define the base of an npn transistor. Estimate the starting concentration of impurity if the base-collector junction lies 1micro-meter below the surface after 2h diffusion at 1100 degrees C.

  State how much energy is transferred

Suppose a 1 meter long bar expands 0.5 centimeters when heated. By how much will a 100 meter long bar of the same material expand when similarly heated?

  Transmitting antenna and a receiving antenna

Calculate the ratio horizon for a 500-ft transmitting antenna and a receiving antenna of 20 ft. Calculate the required height increase for the receiving antenna if a 10% increase in the radio horizon were required.

  Determine what is the time allotted to each channel

A 32 channel TDM system samples messages at 8000 samples per second, uses 2 bits for frame synchronization and 8 bits per sample. What must be the highest frequency in the message spectrum to guarantee perfect recovery of the original signal

  Determine whether the system of equation is bibo stable

d^2y/dt^2 - 6dy/dt +36y(t)=25 dx/dt find the zero input response of the system given y(0)=1 and dy/dt when t=0 = -3 find the Laplace system function, H(s) for the system described by equation Equqtion.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd