What is the minimum grade a student must get in order

Assignment Help Civil Engineering
Reference no: EM13318453

The mean grade on a final examination was 72, and the standard deviation was 9. The top 10% of the students are to receive A's. What is the minimum grade a student must get in order to receive an A ?

Reference no: EM13318453

Questions Cloud

The compound with a three-membered ring containing nitrogen : An epoxide is: Student Response Value Correct Answer Feedback A. any compound with a three-membered ring B. basically a cyclopropane C. any compound with a three-membered ring containing oxygen D. any compound with a three-membered ring containing..
What percent increase in shear force would be experience : What percent increase in shear force would be experience on the flat sides of a 40 ft long truck trailer as the truck speed increases from 65 mph to 75 mph. Kinematic viscosity of the air is 1.6x10^4 ft^2/s.
Determine the number of gallons of paint needed to paint : Determine the number of gallons of paint needed to paint the outside surface of the water-supply tank, which consists of a hemispherical bottom, cylindrical sides, and a conical top. Each gallon of paint can cover 250 ft^2
Find probability that in sample of bulbs will be defective : Find the probability that in a sample of 100 bulbs, (a) 0 bulbs will be defective (b) 1 bulbs will be defective (c) 2 bulbs will be defective (d) 3 bulbs will be defective (e) 4 bulbs will be defective (f) 5 bulbs will be defective
What is the minimum grade a student must get in order : The mean grade on a final examination was 72, and the standard deviation was 9. The top 10% of the students are to receive A's. What is the minimum grade a student must get in order to receive an A
Explain the total molar concentration of all the ions : What is the total molar concentration of all the ions in 0.020 M solutions of the following salts in water. 0.020 M KCl = ____ M ions 0.020 M CuSO4 = ____ M ions 0.020 M CaCl2 = ____ M ions
What is the amount of depreciation expense for 2014 : What is the amount of depreciation expense for 2014?
How many students have heights equal to 68 inches : how many students have heights, (a) Greater than 72 inches (b) Less than or equal to 64 inches (c) Between 65 and 71 inches inclusive (d) equal to 68 inches * Assume the measurements to be recorded to the nearest inch.
Explain the molar concentration of na+ ions solutions : What is the molar concentration of Na+ ions in 0.035 M solutions of the following sodium salts in water

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the maximum deflection of the beam

A hardwood beam of rectangular cross-section 150x300 is simply supported over a span of 8m, and is loaded as sketched. Determine the maximum deflection of the beam. (Youngs modulus E = 12 x 10^3 MPa)

  Determine at what point does the new method pay off

Assume that a new method allows her to sort 20 rings/min but costs $500 to implement. Is it worth implementing the new method for a batch of 50,000 rings. At what point does the new method pay off.

  How long does it take to reach near-steady conditions

Theis Method plot drawdown vs. time for 4 observation wells, 5, 50, 100, 500 meters from well pumping at constant rate of 300 m^3/day in sandy confined aquifer. b=12 m, K=25 m/day, and S=10^-4.

  Calculate the angles made by f with the positive x

A force is specified by the vector F= 120i-160j+80k lb. Calculate the angles made by F with the positive x-,y-, and z- axes.

  Calculate earth gravitational force

Calculate Earth's gravitational force on the Shuttle astronauts while orbiting at an altitude of 220 miles (or 354 km) above Earth's surface.

  Write expression for velocity of point a in terms of theta

The wheel of radius r rolls without slipping and has an angular velocity w. Write an expression for the velocity of point A in terms of theta and show that the velocities of A and B are perpendicular to one another

  Determine what is the maximum column load in kips

What is the maximum column load in kips that could be placed on a 4-ft square temporary footing on a sand for which the standard resistance is about N=15 and the water table is at the surface? A factor of safety of 2 is to be maintained against be..

  Explain how to estimate the capacity of the existing system

The water level of the reservoir is 150 ft above that of the tank. The intake end of the pipeline is square-edged (k=0.5) and the water coes into the tank through a submerged end (k=1). You are told that the pipe is 12 in in diameter

  What is the level of service on a km long percent upgrade

A rural freeway has an ideal free-flow speed of 120 km/h and two 3.6 m lanes in each direction, with right shoulder lateral clearance of 1.2 m. Interchanges are spaced approximately 5 km apart. Traffic consists of 10 percent trucks and buses and 8..

  Estimate range of piezometric head differences to be used

A field sample of medium sand with median grain size of 0.84 mm will be tested to determine the hydraulic conductivity using a constant-head permeameter. The sample has the length of 30 cm and a diameter of 5 cm.

  Determine required diameter of each reinforcing steel bar

If the column is subjected to an axial compressive force of 800 kN, determine the required diameter of each reinforcing steel bar so that one-third of the load is carried by the steel and two-thirds by the concrete. Assume Esteel= 200 GPa and Econ..

  What considerations would made with regards to cement type

You are a construction engineer working on a large concrete foundation project, involving the placement of over 500,000 c.y of concrete. The construction site is adjacent to a salt-water source (bay) & it is decided to set up a concrete batch plan..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd