What is the maximum tensile stress

Assignment Help Civil Engineering
Reference no: EM13559280

A 20-foot long W8X67 is suspended from one end. If the modulus of elasticity is 29,000ksi, determine the following.

a. What is the maximum tensile stress?

b. What is the maximum normal strain?

Reference no: EM13559280

Questions Cloud

Find through what distance does the piston drop : Suppose a monatomic ideal gas is contained within a verticalcylinder that is fitted with a movable piston.  find Through what distance does the piston drop
Determine the inside heat transfer coefficient : The specific heat capacity Cp of the process fluid is not known at the mean bulk fluid temperature but is a linear function of temperature, and must be calculated using the following information, Cp at 300K is 1.98 kJ/kgK, and Cp at 400K is 2.65 kJ/k..
Compute the sample mean variance and standard deviation and : For the grouped data acting as of each of the data point in an interval was actually located at the midppoint of that interval, compute the sample mean,variance and standard deviation and compare with the results above.
What would be the concentration of pollutant in the effluent : A lagoon with volume 1,200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100 m^3/day for a long enough time to assume that steady-state conditions apply. the waste entering the lagoon has a concentration of 10 mg/L. Assumi..
What is the maximum tensile stress : A 20-foot long W8X67 is suspended from one end. If the modulus of elasticity is 29,000ksi, determine the following.
Determine the bending moment at the intermediate support due : A beam is simply supported at the ends and is continuous over two spans. The left-hand span is 16 ft and the right-hand span is 20 ft. The beam supports a uniform load of 900 plf, which includes its own weight,
Determine the volume flow rate from the manning equation : Water flows uniformly in a rectangularlined with a glass surface 0.018, channel width is b=10m, the flow depth is y=0.5m ,slope is =0.008 determine the volume flow rate from the manning equation and the critical depth
Compute what is the half-life of this material : After 2.00 days, the activity of a sample of an unknown type ofradioactive material has decreased to 84.2% of the initialactivity. What is the half-life of this material
Describe the type of solution you obtained and clearly state : Using a graphical approach, determine the optimal amount of Space Rays and Zappers that need to be produced in order to maximize profits every week. Describe the type of solution you obtained and clearly state your choice of decision variables, objec..

Reviews

Write a Review

Civil Engineering Questions & Answers

  1 you are working for urs on a building project in dearborn

1. you are working for urs on a building project in dearborn michigan. you are responsible for the design of the

  What would be the the depth of water im millimeters on land

a tank contains 650 cubic feet of water.the water will be applied on 7 acres of land. What would be the the depth of water im millimeters on the land assuming that there are no losses

  Determine at what ocean level h will the gate first open

Gate AB is 4m wide into the paper and opens to let fresh water out when the ocean tide is dropping. The hinge at A is 0.50m above the freshwater level. At what ocean level h will the gate first open

  Estimate the minimum pressure needed in the chamber

The "supersoaker" water gun can shoot more than 30 ft in the horizontal direction. Estimate the minimum pressure, , needed in the chamber in order to accomplish this. List all assumptions and show all calculations.

  Which reactor is more efficient and why

There are three reactors degrading a chemical biologically, at three degradation rates; i.e., 0.2 d^-1, 0.4 d^-1, and 1.0 d^-1. The residence time of the chemical in these reactors are 10 d, 5 d, and 55 d, respectively

  Compute the elevations at 100-ft stations throughout the

A 800 m vertical curve joins a -3% grade line to a 5% grade line. The PVI of the curve is at station 6200 and its elevation is 600.6 ft. Compute the elevations at 100-ft stations throughout the curve.

  What is its specific weight

If water vapor in the atmosphere has a partial pressure of 3500 Pa and the temperature is 30 degrees Celsius, what is its specific weight?

  Use the bernoulli equation

Use the Bernoulli equation to describe how this manometer can be used to measure the flow rate through the meter.

  Calculate percipitable water in standard atmoshperic column

Calculate the percipitable water (mm) in a 10-km high standard atmoshperic column if the surface conditions are temperature=20 degrees C, pressure=101.3 kPa and the laspe rate is 6.5 degrees C/km.

  Calculate fraction of total atrazine that will be adsorbed

Calculate the fraction of total atrazine that will be adsorbed to the soil given that the soil has an organic carbon content of 2.5%. The bulk density of the soil is 1.25 g/cm3; this means that each cubic centimeter of soil (soil plus water) conta..

  A 1 18 45 mix has a watercement ratio of 06 and a cement

a 1 1.8 4.5 mix has a watercement ratio of 0.6 and a cement content of 300 kgm3. the temperature of the ingredients

  Calculate the ifov corresponding to the spatial resolution

LANDSAT as a spatial resolution of 15m and an altitude of 700km. IKONOS has a spatial resolution of 1m and an altitude of 680km. Calculate the IFOV corresponding to the spatial resolution for sensor.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd