What is the maximum rate at which the current changes

Assignment Help Physics
Reference no: EM13559301

An oscillating LC circuit has a current amplitude of7.30 mA, a potential amplitude of 250mV, and a capacitance of 205 nF.

(a) What is the period of oscillation?

µs

(b) What is the maximum energy stored in the capacitor?

nJ

(c) What is the maximum energy stored in the inductor?

nJ

(d) What is the maximum rate at which the current changes?

A/s

(e) What is the maximum rate at which the inductor gainsenergy?

mW

Reference no: EM13559301

Questions Cloud

Estimate the daily emissions of particles from a solid-waste : Estimate the daily emissions of particles from a solid-waste incinerator emitting at 0.18g/dscm. The incinerator burns 50 tonnes per day (1 tonne= 1 metric ton= 1000kg) and exhausts gases in a ratio of 20kg of gases per kg of feed
Find the resulting compressional force on the earth : suppose that 1.00g of ydrogen is seperated into electrons andprotons. supoose also that the protons are placed at theEarth's North Pole,  What is the resulting compressional force on the Earth
Determine the horizontal distance the shot travels from the : When the athlete releases the shot, it is 1.88 above the ground and its initial velocity is = 13.6 . The angle of the release is 30 degrees. Determine the horizontal distance the shot travels from the point of release to the point where it hits the g..
How far are you from the lightning stroke : Suppose that you hear a clap of thunder 16.2s after seeing theassociated lightning stroke. How far are you from the lightning stroke
What is the maximum rate at which the current changes : An oscillating LC circuit has a current amplitude of7.30 mA, a potential amplitude of 250mV, and a capacitance of 205 nF. What is the maximum rate at which the current changes
Calculate the low point of the curve if the intersection at : A vertical parabolic curve is to be used as a sag curve, and it is desired to know the location and elevation of the low point. The curve is 750ft long , and the minus grade of 3.6 percent intersects the plus grade of 6.2 percent at station
What is the rotor''s angular velocity one minute after : The rotor of an electric generator is rotating at 200 when the motor is turned off. Due to frictional effects, the angular acceleration of the rotor after the motor is turned off is α=-0.01ω rad/s^2 , where is the angular velocity in rad/s.
Estimate how much coffee has spilled out of the beaker : During an all-night cram session, a student heats up a (0.7 x 10-3 m3) glass (Pyrex) beaker of cold coffee.Initially, the temperature is 18°C, How much coffee(in cubic meters) has spilled out of the beaker
How much would the answer change : A buried horizontal concrete pipe (n=0.012) of unknown length needs to be replaces. the length is not known because the original plans for the pipeline route have been lost.

Reviews

Write a Review

Physics Questions & Answers

  Wavelengths permitted for the electrons de broglie waves

An electron is trapped in an infinite well of width 0.120 nm. What are the three longest wavelengths permitted for the electron's de Broglie waves?

  What is the force acting on the electron

An electron is brought to a point 0.2m from the center of a conducting sphere of radius 0.1m carrying a charge of 4.0x10^-6 C, What is the force acting on the electron

  Determine what is the melting point of potassium

A platinum resistance thermometer has resistances of 200.0 ? when placed in a 0?C ice bath and 253.8 ?, What is the melting point of potassium

  Find what is the spring constant

Coherent light with wavelength 609nm passes through two very narrow slits, and the interference pattern is observed on a screen a distance of 3- {rm m} from the slits. The first-order bright fringe is a distance of 4.84 {rm mm} from the center of ..

  What is the efficiency of theramp

A force of 1250N is needed to move a crateweighing 3270N up a ramp that is 4.55m long. if the elevated end ofthe ramo is 0.750m high, what is the efficiency of theramp?

  Find by how many celsius degrees should the rod be cooled

A commonly used method of fastening one part to another part is called "shrink fitting." A steel rod has a diameter of 2.0023 cm, By how many Celsius degrees should the rod be cooled

  Lengths of the rods measured by someone in frame k

Frames k and k' are inertial frames. Frame k' is moving at a velocity of magnitude v realtive to frame k in the direction of the x-axis. there are rigid rods in each frame oriented along the direction of the relative velocity. someone in frame k meas..

  By what percentage does the intensity increase

At a rock concert, the engineer decides that the music isn't loud enough. He turns up the amplifiers so that the amplitude of the sound, By what percentage does the intensity increase

  What is the runners displacement from starting point

A runner, jogging along a straight line path, starts at a position 260 m east of a milestone marker and heads west. After a short time interval he is 120 m west of the mile marker.

  How fast is the train moving

A person looking out the window of a stationary train notices that raindrops are falling vertically down at a speed of 4.57 m/s relative to the ground. How fast is the train moving

  What is the angular speed of the lazy susan

A Texas cockroach of mass 0.123 kg runs counterclockwise around the rim of a lazy Susan (a circular disk mounted on a vertical axle) that has a radius 16.6 cm, What is the angular speed of the lazy Susan after the cockroach stops

  Determine the work done by the pushing force

A person pushes a 17.2-kg shopping cart at a constant velocity for a distance of 24.2 m on a flat horizontal surface. Determine the work done by the pushing force

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd