What is the maximum height

Assignment Help Civil Engineering
Reference no: EM13207675

The height (in meters) of a projectile shot vertically upward from a point 2 m above ground level with an initial velocity of 24.5 m/s is h2+24.5t-4.9t^2 after t seconds. a) When does the projectile reach its maximum height? b) What is the maximum height?

Reference no: EM13207675

Questions Cloud

Guffey and loewys seven ethical guidelines : A clothing manufacturer produced a T-shirt emblazoned with a ferocious red and blue eagle beneath the words "American Made." However, a small label inside revealed that the shirt was made in Mexico.
Calculate the ifov corresponding to the spatial resolution : LANDSAT as a spatial resolution of 15m and an altitude of 700km. IKONOS has a spatial resolution of 1m and an altitude of 680km. Calculate the IFOV corresponding to the spatial resolution for sensor.
Are there any situations when parallel flow option : Are there any situations when parallel flow option may be preferred instead of a counter flow heat exchanger
Find the direction of flow : A conical tube of length 8 m fixed vertically with its smaller end upwards. The velocity head and pressure head at upper ends are 1.27 m and 2.50 m respectively. The velocity head and pressure head at lower ends are 0.203 m and 5.407 m respectivel..
What is the maximum height : The height (in meters) of a projectile shot vertically upward from a point 2 m above ground level with an initial velocity of 24.5 m/s is h2+24.5t-4.9t^2 after t seconds. a) When does the projectile reach its maximum height? b) What is the maximum..
How low does p have to be before kyle is better job : Kyle is an English PhD student; there is some chance he will get a prestigious university job that will pay him $80,000/year (probability p). If he does not get this job, he will have to take a job at Starbuck's, paying $25,000/year.
Naturalist worldview and someone with a christian worldview : How would the decision making process regarding money and career differ between someone with a Naturalist Worldview and someone with a Christian Worldview?
Determine which motor should be installed based on the pw : At the end of 15 years, the first motor will have a salvage value of $50 and the second motor will have a salvage value of $100. consider the MARR to be 8%. (note : 1HP=0.7457 kw). Determine which motor should be installed based on the PW criterio..
What is the net upward force exerted : the pressure inside a commercial airliner is maintained at 1.00 ATM. what is the net upward force exerted on a (1.0 m)(200 cm) cabin door if the outside pressure is 0.30 ATM?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Parallel tangents of a reversed curve

The perpendicular distance between two parallel tangents of a reversed curve is 20m. The azimuth of the back tangents of the curve is 270 00 and the azimuth of the common tangent is 310.

  Dry unit weight of material

A soil borrow material in its natural state in the ground has a unit weight of 118pcf. Its natural water content is 7%. What is the dry unit weight of this material?

  Cylindrical pressure vessel with hemispherical ends

A cylindrical pressure vessel with hemispherical ends has a 2.5-m radius and a 5-mm wall thickness. It contains a gas with pressure pi = 6×10 5 Pa and the outer wall is subjected to atmospheric pressure p 0 = 1 × 10 5 Pa.

  Establishing a horizontal distance

A tape is calibrated and found to measure 100.04ft between the 0- and 100-ft marks. What measurements should be laid out to establish a horizontal distance of 682.25ft?

  Determine the theoretical discharge

A vertical triangular orifice in the wall of a reservoir has a base 0.9m long,0.6m below its vertex and 1.2 m below the water surface. Determine the theoretical discharge?

  Volume of the lake

Suppose that the distance from the lake outlet to the withdrawal cannot be more than 20 mi. What should be the new volume of the lake?

  Force that cause stress-free

The rigid bar abcd is supported by a pin at B and restrained by identical steel bars at C and D, each of area 250mm 2 . if the temperature is increased by 8 0 C, find out the force P that will cause the bar at c to be stress-free.

  Determining the amount of investment

If they plan to increase their savings by 5% each year, how much must they invest in the first year given that they expect to earn 4% per year on their investment?

  Superelevation rate for a roadway

What superelevation rate would you recommend for a roadway with a design speed of 100 km/hr and a radius of curvature of 500 m? Assume f = 0.11.

  Compute the maximum acceptable tensile load

Compute the maximum acceptable tensile load Pu, on an angle L6x4x3/4 when connected to both legs. The 4 in. leg contains a single gage line of 7/8in. diameter bolts, and the 6in.

  Structure project design in civil engineering

Land is extremely valuable in this area therefore to win this job you need to consider innovative approach to reduce the waste areas

  Hydraulic behaviour in open channel

Describe how test flumes and associated equipment are used to assess and confirm hydraulic behaviour in open channel

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd