What is the incoming velocity

Assignment Help Civil Engineering
Reference no: EM131238532

1. I drive down the highway at 110 km/h on a 25?C, 101.3 kPa day. I put my hand, crossesctional area 0.01 m2, flat out the window. What is the force on my hand and what temperature do I feel?

2. A stagnation pressure of 110 kPa is measured for an air flow where the pressure is 100 kPa and the temperature is 20?C in the approach flow. What is the incoming velocity?

Reference no: EM131238532

Questions Cloud

Find the probability that tail shows up exactly twice : A coin is tossed 5 times. The probability of tails on any toss is 0.43. Let x denote the number of tails that comes up. a) Find the probability that tail shows up exactly twice. b) Find the probability that tail shows up at most once.
Point estimate of the proportion of all employees : (a) Calculate a point estimate of the proportion of all employees who would attend the program. (b) Find a 90% confidence interval for the proportion of all employees who would attend the program.
Discuss role of culture and diversity in educational setting : What defines diversity? Discuss the role of culture and diversity in educational settings - what are the potential challenges for learners, educators and educational leaders?
What alternative hypothesis should be used : Let p denote the probability that a juror drawn by the judge is a woman. Then to test the judge's fairness in selecting women, what null hypothesis should be used? What alternative hypothesis should be used?
What is the incoming velocity : A stagnation pressure of 110 kPa is measured for an air flow where the pressure is 100 kPa and the temperature is 20?C in the approach flow. What is the incoming velocity?
Find the nozzle exit area the required pressure out of pump : Neglect elevation differences and the kinetic energy of the water flow in the pump and hose to the nozzle. Find the nozzle exit area, the required pressure out of the pump, and the horizontal force needed to hold the cannon.
What measures did you take to overcome the challenges : In what way did they challenge you? What measures did you take to overcome the challenges? What is your learning from these challenges that you would like to share with your classmates?
Find the standard deviation of incomes : For a sample of 87 entry level managers you find the standard deviation of incomes is 3,099 (measured in dollars). What is the standard error? Answer to one decimal place.
Use a karnaugh map to reduce the logical expressions : Design the desired truth table (inputs T1, T0, N, C) for the outputs U, Q and S. - Use a Karnaugh map to reduce the logical expressions for the functions U, Q and S to a minimal SOP form.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the optimal distance between the two drainage

To avoid the salinization of soil in a farming area, parallel drainage canals are to be installed to maintain the water table at a depth of at least 4m below the ground surface.

  Determine the reaction at the fixed end a

A 6-m telephone pole weighing 1600 N is used to support the ends of two wires. The wires form the angles shown with the horizontal and the tensions in the wires are, respectively, T1 = 600 N and T2 = 375 N. Determine the reaction at the fixed end ..

  What is the annual crash rate for section of college street

Over the past 3 years, there have been 14, 13, and 15 crashes on this section of College Street. The two-way ADT on this section is 16,474 vehicles per day. What is the annual crash rate for this section of College Street

  Calculate the fraction

And forms HCN, it will volatilize, and if it volatilizes, HCN can poison mine workers. At pH 10.4, what fraction of the cyanide is in the CN- form?

  Find the expected transmitted energy per binary digit

That is, the transmitter sends a/gm/ instead of a. Find the expected transmitted energy per binary digit.

  What shear stresses exist at mid depth

A rectangular beam of width 300 mm and depth 450 mm supports loads producing a shear force of 300 kN at a particular section. What shear stresses exist at the following points?

  Determine the heat loss or gain during the process

A piston-cylinder device contains helium gas initially at 150 kPa, 20 degrees C, and 0.5 m^3. The helium is now compressed in a polytropic process (PV^n = constant) to 400 kPa and 140 degrees C.

  Determine the settlements

Determine the settlements when a stress of 100 kPa is applied by the building over an area of 10m × 5 m on the soil surface.

  How much could he exert if he moved his hands to the ends

A plumber places his hands 18 inches apart on a pipe threader and can push (and pull) with 80 lb of force. What couple moment does he exert? How much could he exert if he moved his hands to the ends so that his hands are 254 inches apart?

  Determine max speed of the bicycle neglect rolling friction

The specific weight of aire is .075 lb/ft^3. The physiological limit of the power for this well trained cyclist is .5 hp (1hp=550 ft*lbs/s) Neglect rolling friction, find the max speed of the bicycle.

  How could the process be made reversible

Heat in the amount of 150 kJ is transferred directly from a hot reservoir at TH= 550 K to two cooler reservoirs at T1 = 350 K and T2 = 250 K.

  Calculate the change in the spheres internal energy in kj

During the process 40 kJ of heat is transferred from the sphere, while the sphere receives energy in the form of work equal to 20kcal. calculate the change in the sphere's internal energy in kJ.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd