What is the illumination on the corners of the bench

Assignment Help Electrical Engineering
Reference no: EM13275542

A point source light of 9000 cd is mounted 3.3m above the centre of a work bench.The bench measures 4m x 4m, what is the illumination on the corners of the bench ?

Reference no: EM13275542

Questions Cloud

Determine the equivalent capacitance of the combination : Two capacitors, C1 = 6.00 µF and C2 = 14.0 µF, are connected in parallel and the resulting combination is connected to a 9.00 V battery. What is the equivalent capacitance of the combination
What is the annual rate of return on the bond : If a United States Savings bond can be purchased for $29.50 and has a maturity value at the end of 25 years of $100, what is the annual rate of return on the bond? (Please calculate the arithmetic solution and show your work)
Find the pole frequency fc for the fourth pole : A certain amplifier has pole frequencies of f1=f2=f3=50MHz. The DC open-loop gain is 10^5. Find the pole frequency fc for the fourth pole so that the phase margin is 30 degrees for beta = 0.1 Also, find the corresponding gain margin.
The term construction management : The term " construction management " (CM) has caused some confusion in the construction industry over what CM represents. Some in the industry recognize CM as existing only in the construction phase as opposed to throughout the entire project. Knowin..
What is the illumination on the corners of the bench : A point source light of 9000 cd is mounted 3.3m above the centre of a work bench.The bench measures 4m x 4m, what is the illumination on the corners of the bench ?
Find the inductive and capacitive reactance at resonance : in a RLC series circuit R=500Ω L=0.4mH and C=100pF the circuit is connected to the terminals of an ac source with an rms voltage of 1V, and a variable frequency calculate the following A) resonant frequency
Explain iodine does not have a permanent dipole : Iodine does not have a permanent dipole and is therefore a non-polar molecule. Why Iodine does not have a permanent dipole a) electronegativities of two iodine atoms are identical b) two iodine atoms will cause partial charge separation
What is the interest payment due in month : What is the interest payment due in month 30 of on a fixed rate mortgage that has an annual interest rate of 5% and an initial principal value of $200,000? (a) $802 (b) $402 (c) $602 (d) $500
What is the power needed to operate the tow : A ski tow operates on a slope of angle 15.3? of length 330m, Whats the power needed to operate the tow

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine all of the prime implicants of f

F(a,b,c,d) = Σ m(7, 11, 12, 14) + Σ d(0, 10) (a) Find all of the prime implicants of F'. (b) Find a minimum product-of-sums for F. Note: F' is specified in (a) and F in (b).

  Express p and a in cylin and spher cordinates

Giiven point p( -2 6 3) and vector a=yax +(x+z)ay. Express p and a in cylin and spher cordinates.eval a and p in the cartesian,cylin,and spherical systeem

  Determine the emitter voltage and emitter current

Using DC Operating point analysis in Multisim (DO NOT USE MULTIMETER INSTRUMENT-NO CREDIT) determine the emitter voltage and emitter current. Provide a screenshot of the results window.

  What is the value of resistance that must be chosen

Imagine a circuit consisted of two DC power sources of 12 volt and 10 volts. The negative terminals of these power sources are wired together. Assume that the positive terminals of these power sources are labeled as A and B respectively.

  What is the current through the resistor

A 1.0 dc voltage source is connected across a 10 ohm resistor. What is the current through the resistor if (a) the voltage source is ideal (b) the voltage source has internal resistance 0.1 ohm (c) internal resistance 1.0 ohm

  Find how many kilobytes of memory are there on the chip

If memory on a single memory chip ranges from address 100000H to 8FFFFH, how many kilobytes of memory are there on this chip if the memory is byte addressable

  Determine the number of bits required per character

The American Standard Code for Information Interchange (ASCII) has 128 binary-coded characters. If a certain computer generates 100,000 characters/second, determine the following: a. The number of bits (binary digits) requiredper character.

  Will the behavior of the circuit when step input is applied

Now, suppose that an initial voltage of 1V is present at the capacitor at zero time (t = 0). Will the behavior of the circuit when a step input is applied still yield an exponential rise or will the behavior be of some other type

  Determine the capacitance values for each case

Simulate the second-order RLC circuit using simpower Matlab simulink.This circuit has DC source voltage Vs=220V, Inductance L=2mH and Resistance R=160 ohms.Determine the capacitance values for each case

  How to relate resistance to transconductance of vccs

Prove that the terminals of a voltage controlled current source (VCCS) can be connected so as to form a 2 terminal element that behaves exactly like a resistor.

  Prove that the electrons will not reach the positive plate

Electrons are liberated with zero velocity from the negative plate of a parallel plate capacitor, to which is applied a magnetic flux density B parallel to the plates. Prove that these electrons will not reach the positive plate.

  Describe the sequence of steps needed to create 3 labels

The frame object from question 1 uses a BorderLayout by default. Write Java statements to create a JTextfield object and place it into the bottom part of the frame object's window. Describe the sequence of steps needed to create 3 labels and place

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd