Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
the SABER instrument aboard the TIMED satellite orbits the earth in a sun-synchronous polar orbit 625 Km above the earth. each of the 10 SABER focal plan detectors is 0.14mm high by 2.0mm wide. the focal plane array is 4.882*4.882mm in size with a field of view of 1,4*1.4. assume that the mean radius of earth is 6.368000 Km. what is the footprint of the entire focal plane array at the tangent point 100Km above the earth? what the footprint of each individual detector at that same location?
Write a short report that analyses the P&ID - Basic Neutralizer Control System: The neutralizer process may be used to adjust the pH of a feed stream.
Three loads are connected in parallel across a single-phase source voltage of 240 V (RMS). Load 1 absorbs 12 kW and 6.667 kVAR; Load 2 absorbs 4 kVA at 0.96PF leading; Load 3 absorbs 15 kW at unity power factor.
Finding values of a composite discrete time signal, A discrete time signal x(n) = x(n-1) + x(n-3) with initial conditions x(0) = 0, x(1) = 1 and x(2) = 2 is examined and the first 51
What are the transfer function and the impulse response of the system?
Determine the relative permittivity of the dielectric, the maximum and minimum electric field intensities in medium 1 and the electric field intensity in medium 2.
A series of combination having R=2Mohm and C=0.01 UF is connected across a D.C. voltage source of 50V. Determined capacitor voltage and charging current after 0.02s, 0.04s and 1 hour.
This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.
Consider a satellite communication link with a one way propagation delay of 300ms between the sender and receiver, operating at 10Mbps using packets of length 1500bytes. Length of the ACK packet is also 1500 bytes.
A single-phase, half-wave SCR circuit is used to control the power consumption of an inductive load. The resistive component of the load is 5 Ohm. The source voltage is 120 V (rms). When the triggering angle is adjusted to 60 degrees
pressure limits of 10 kPa and 8 MPa, with reheat occurring at 4 MPa. The temperature of steam at the inlets of both turbines is 500°C, and the enthalpy of steam is 3185 kJ/kg at the exit of the high-pressure turbine
a) what is the frequency f, of the ac circuit signal b) what is the period, T, of the ac circuit signal what is the angular velocity/frequency (omega), of the ac signal if v(t) = 24 cos (2pie 500t).
A 250hp, 500v dc shunt motor draws a nominal field current of 5A under rated load. The resistance is 90ohms. Calculate the ohmic value and power of the series resistor needed so that the field current drops to 4.5A
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd