What is the coefficient of permeability

Assignment Help Civil Engineering
Reference no: EM13559208

An aquifer is 45 meters deep and has a well that pumps water at 850 cubic meters per day. One observation well is located 45 meters away and has a water surface that is 44.35 meters above the bottom of the aquifer. A second observation well is located 85 meters away and has a drawdown of 0.25 meters. What is the coefficient of permeability?

Reference no: EM13559208

Questions Cloud

Strict cultural value system at work : The strict cultural value system at work in the novel's villages and clans. Right and wrong appear, at times, incredibly rigid. Focus on the main character, Okonkwo. What does he value most and why?
What is the max length to which it may be stretched without : For an unknown alloy the stress at which plastic deformation begins is 400MPa and the modulus of elasticity is 120GPa. If the original specimen length is 76 mm
What is the anle of internal friction for the sand : A direct shear cell 25.4cm x 25.4 cm in plan is filled with dry sand. a normal load of 6kN is applied to the sample, and the shear failure is 3.5kN. What is the anle of internal friction for the sand?
Fellowships and honors kate chopin earned : List five authors Kate Chopin had a strong influence on - list 25 works of Kate Chopin and specify Title
What is the coefficient of permeability : An aquifer is 45 meters deep and has a well that pumps water at 850 cubic meters per day. One observation well is located 45 meters away and has a water surface that is 44.35 meters above the bottom of the aquifer.
Write the negative message effectively : Writing in a professional context must create negative messages, such as a letter of termination, a press release regarding a company error, a denial of a claim, or a poor performance review.
Determine the nominal flextural strength of the section : A rectangular beam with a width of a 8 in. an effective depth of 10 in., and a total depth of 12 in., is reinforced with a single fiberglass reinforcing bar that has a cross sectional area of 0.45 in^2
Find the direction of the combined mass : an 8000 kg truck traveling with a velocity of 20.0m/s in a direction 30 (degree) south of east, find the direction of the combined mass
A water tank consists of a cylindrical part of radius r and : A water tank consists of a cylindrical part of radius r and height h, and a hemispherical top. The tank is to be constructed to hold 500 m3 of fluid when filled. The surface area of the cylindrical part is (2*pi*r*h)

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the angle between the resultant force

Here are 3 forces acting on the ring. using the non vector approach, determine the resultant force of only the 150 Ib and 100 Ib forces. Also calculate the angle between the resultant force and the positive x axis.

  Determine the planer density and packing faction for fcc

determine the planer density and packing faction for FCC nickel in (100), (110), and (111 planes. which, if any, of these planes is close-packed

  How high did the ball roll before it momentarily stopped

A solid ball starts to roll up a hill with an initial velocity of 50m/s. The ball has a mass of 20 Kg with a 0.75 m radius. How high did the ball roll before it momentarily stopped

  A gas is contained in a vertical friction less piston

A gas is containied in a vertical frictionless piston cylinder device. the piston has a mass of 20kg with a cross-sectional area of 20cm^2 and is pulled with a force of 100n. if the atmospheric pressure is 100kpa determine the pressure inside.

  Develop an estimate of the volumetric flow rate of air

Develop an estimate of the volumetric flow rate of air that will be required for aeration of the mixed liquor in an activated sludge system.For this calculation, assume that the (ultimate) CBOD is 200 mg/L and (ultimate) NBOD is 50 mg/L.

  Determine the largest positive value p the structure can

The structure consists of two uniform members AB and BC, each weight 2kN. The member are pinned to each other at B, and the structure is supported by a pin at C and a surface at A having coefficient of static friction 1.2. Determine the largest posit..

  Source and destination addresses of router solicitation

Source and destination addresses of router solicitation, Given an IPv6 network, assume a host using EUI-64 addressing has a MAC address of00:24:E8:3D:CA:35

  Determine the magnitude and direction of the resultant

Part of the roof of a sports stadium is to be supported by the cables AB and AC. The forces the cables exert on the pylon A to which they are attached are represented by the vectors FAB and FAC.

  Calculate the hydraulic conductivity if the porosity of sand

A constant-head test was conducted on a sample of soil 15cm long and 60 cm^2 in cross-sectional area. The quantiities of water collected was 50 cm^3 in 20 seconds undera a head difference of 24 cm.

  Compute the maximum acceptable service load

Compute the maximum acceptable service load on an A36 steel plate tension member 1/4in.x12in. having a single line of holes parallel to the direction of loading. The load is 25% dead load and 75% live load, and 7/8in. diameter bolts are used.

  Write a program that processes a sequence of lines

Write a program that processes a sequence of lines from a file, displaying a count of the total number of words in those lines as well as counts of words with one letter two letters,and so on.

  Determine the water ph for a contact time of 90 minutes

In Chlorine disinfection (3-log reduction in Giardia- Cysts), determine the water pH for a contact time of 90 minutes using a chlorine concentration of 2 mg/L at 20 degrees C

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd