What is the checksum value that is computed

Assignment Help Other Engineering
Reference no: EM13868072

1. Consider the following subnet in which the routers are labeled A through F. Distance vector routing is used, and D's routing table initially contains only information about reaching C and F (its nearest neighbors). In other words, D has not received any update messages yet.

Suppose the following vectors have just come into router D: From C: (13, 4, 0, 6, 6, 14) From F: (10, 12, 16, 14, 2, 0) The measured delays to C and F are 4 and 97 respectively.

What is C's new routing table? Give both the outgoing line and the expected delay.

Dest. Outgoing Line Delay A B C E F

2. What is the fastest line speed at which a host can blast out 1500-byte TCP payloads with a 120- sec maximum packet lifetime without having the sequence numbers wrap around?

Take TCP, IP, and Ethernet overhead into consideration. Assume that Ethernet frames may be sent continuously.

3. Consider the network shown: Assume that the weight on the lines is the currently known link delay. Run Dijkstra's algorithm to find the shortest paths from source node A to all other nodes in the network.

Show all your work (show the intermediate tables you generate)

4. Consider the network shown in the previous problem. Run the non-distributed Bellman-Ford algorithm to find the shortest paths from source node A to all other nodes in the network.

Show all your work (show the intermediate tables you generate)

5. Given a router with 4 interfaces/links which are labeled 0 - 3, and a forwarding table as follows:

IP Prefix Output Link 192.168.0/17 0 192.168.32/19 1 192.168.64/18 2 192.168.127/24 3 192.168.128/18 0 192.168.160/19 1 192.168.186/24 2 192.168.191/24 3 192.168.192/18 0 What interface will a packet with a destination IP address of 192.168.96.75 be sent out on?

6. Suppose Host A sends three TCP segments back to back to Host B over a TCP connection. The first segment has sequence number 120. The second segment has sequence number 121. The third segment has a sequence number of 1145. How much data is in the first segment? How much data is in the second segment? How do you know?

7. Consider the Go Back N protocol with 8 bit sequence numbers (i.e., a sequence number space of size 256). What is the largest allowable sender window that will avoid the occurrence of the problem where a new packet is indistinguishable from a retransmission?

8. Consider the Selective Repeat protocol with 8 bit sequence numbers (i.e., a sequence number space of size 256). What is the largest allowable sender window that will avoid the occurrence of the problem where a new packet is indistinguishable from a retransmission?

9. Consider the effect of using slow start on a line with a 10-msec round-trip time and no congestion. The receive window is 24 KB and the maximum segment size is 2 KB. How long does it take before the first full window can be sent?

10. Suppose datagrams are limited to 1500 bytes (including the header) between source and destination. Assuming a 20 byte IP header (with no options present), how many datagrams would be required to transfer a video file consisting of 500,000,000,200 bytes.

11. Suppose a UDP segment contains the following data: 00001001 01101001 00100011 01111100 00000000 00010100 00000000 00000000 11110000 11110000 00001111 00001111 10101010 01010101 01010101 10101010 11111111 00000000 11001100 00110011

Suppose a segment checksum needs to be computed for this segment.

What is the checksum value that is computed? Where is this checksum placed in the segment? Assuming there are no errors during transmission of the segment, what do you expect the verification step to produce as a result when verifying the checksum on the receiver?

12. Suppose two packets arrive to two different input ports of a router at exactly the same time. Also, suppose there are no other packets anywhere in the router. If the packets are to be forwarded to two different output ports, is it possible to forward the packets through the switch fabric at the same time when the fabric uses a shared bus? Is it possible to forward the packets through the switch fabric at the same time when the fabric uses a crossbar? Explain.

Reference no: EM13868072

Questions Cloud

Differences between emily and the grandmother : differences between Emily and the Grandmother
Cost of equipment and participation : Cost of equipment and Participation
Determine the mass flow rate required for a power output : Steam enters an adiabatic turbine at 10 NIPa and 500°C and leaves at 10 kPa with a quality of 76 percent. Neglecting the changes in kinetic and potential energies, determine the mass flow rate required for a power output of 4.21 MW. - I kg's (Round t..
What is the probability of exactly two failures : Based on the first 113 missions, and assuming failures occur at the same rate, consider the next 23 missions. What is the probability of exactly two failures? What is the probability of no failures?
What is the checksum value that is computed : What is the fastest line speed at which a host can blast out 1500-byte TCP payloads with a 120- sec maximum packet lifetime without having the sequence numbers wrap around?
Design a filter that meets the criteria : Problem 1: Design a filter that meets the criteria based upon the number that you picked.
Employers often use employment tests to screen applicants : Employers often use employment tests to screen applicants and to assist in selecting the most qualified individual for the job. They can be very effective tools. There are many different types of tests, including cognitive tests, credit checks, crimi..
What was the maturity amount of the bonds : Complete the amortization schedule. What was the maturity amount (face value) of the bonds? How much cash was received at date of issuance (sale) of the bonds? Was there a premium or a discount? If so, which and how much was it? How much cash is paid..
Find probability that four golfers would score a hole : There were 155 golfers participating in the second round that day. Estimate the probability that four golfers would score a hole in one on the sixth hole.

Reviews

Write a Review

Other Engineering Questions & Answers

  Issue that has national and global implications

Describe environmental issue that has national and Global implications. For this issue, develop a Policy Initiative for a private organisation.

  Determine refractive index and kerr effect and possibly fbg

Simulation of an optical fibre SMF-28 using OPTSIM (RSOFT) software to determine the refractive index and kerr effect and possibly FBG and report

  Define goal model fragment for an air traffic control system

Consider the following goal model fragment for an air traffic control system shown below. The parent goal roughly states that aircraft routes should be sufficiently separated.

  Describe how security administration works to plan

Describe how security administration works to plan, design, implement, and monitor man organization's security plan.

  What is strategic management and what are some of its major

What is strategic management and what are some of its major objectives? Explain in two paragraphs.

  Assessment instructionsthis outcome is assessed using all

assessment instructionsthis outcome is assessed using all three of the assignments detailed below.nbsp for each

  Show a meaningful block diagram

Show a meaningful block diagram and a brief description of its architecture and summarize the key architectural features of these microcontrollers that you, as a designer, view important.

  Write a paper about digital tools and effective strategies

Write a paper about Digital Tools and Effective Strategies for Engaging the Adult Learner by David Jones.

  Parameters to work out the speed

Select any passenger or F1 race car, collect data from the web information, Identify all the parameters to work out the speed of 0-100 KM/Hr in 7 seconds and 4 seconds for Passenger and F1 race car respectively.

  How thermoelecteric thermometer is contructed

How thermoelecteric thermometer is contructed and how it working

  Calculate the formation factor for both cores and the model

Calculate the formation factor (F) for both cores and the model (using both values of mf) and plot all your results on a standard log-log cross-plot of F vs. porosity.

  Write procedures to manipulate queues

Write a procedure (make-queue) that produces independent first-in-first-out queue objects, using a message-passing style.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd