Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A runway can serve all 868 or all other jets? Assume the minimum time separation in the approach area is 60 seconds for all 868 and 50 seconds for all other jets. All jets including 868 have a runway occupancy time of 60 seconds. The 868 can carry an average payload of 360 passengers while all other jets have an average payload of 200 passengers.
What is the capacity of the runway when only 868 will be served?
What is the largest capacity in passenger per hour?
A rectangular beam with a width of a 8 in. an effective depth of 10 in., and a total depth of 12 in., is reinforced with a single fiberglass reinforcing bar that has a cross sectional area of 0.45 in^2
A structure is designed with a factor of safety of 5.25 psi. If the allowable stress of the structure is 3000 psi. What stress on the structure will lead to its failure?
A newly designed car has a 9.2 ft wheelbase, is rear wheel drive, and has a center of gravity 18 inches above the the road and 4.3 ft behind the front axle. the car weighs 2450 lb
A composite beam is made by attaching the timber and steel portions with bolts of 14-mm diameter spaced logitudinally every 200 mm. The modulous of elasticity is 10 GPa for the wood and 180 GPa for the steel.
A 30 g bullet is fired with a horizontal velocity of 450 m/s through 3-kg block B and becomes embedded in carrier C which has a mass of 30 kg. After the impact, block B slides 0.3m on C before coming to rest relative to the carrier.
The coefficient of rolling resistance can be taken to be a constant for all speeds, equal to 0.008. If the cyclist is coasting down a 6% grade, what is the maximum speed attained
Determine the maximum concentrated load that can be applied at the center of a 6 in. X 6 in. simply-supported plain concrete beam before it cracks in tension.
Write the equations required to express the shear and moment along the entire length of beam. Use an origin at point A, and then repeat computations using an origin at point D. Plot the shear and moment across the beam.
Determine from curve (a) critical depth (b) the maximum flow rate (c) the flow rate at a depth of 2.4 m and (d) the depths at which flow rate of 28.3 m^3/s may exist and the flow conditions at these depths.
A rubber ball is inflated to a pressure of 65 kPa .At that pressure the diameter of the ball is 240mm and the wall thickness is 1.25 mm.The rubber has a modulus of elasticity E of 3.6 Mpa and a poisoon'd ratio of 0.48.
investing in the General Motors costs $10,000 today and pays back $11,500 two years from now. If investing in the Ford costs $8,000 today and pays back $4,500 each year for two years, which alternative is inferior
commercial management in civil engineering 1-critically analyse the use of project related commercial risk registers
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd