Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An aeration system with a hydraulic retention time of 2.5 hours receives a flow of 0.2 MGD with BOD concentration of 150 mg/L. The suspended solids concentration in the aeration basin is 4,000 mg/L. a) Calculate the F/M ratio for this system. b) If sludge from this system is being wasted at a rate of 500 gal/day (1.5% solids dry weight, Specific Gravity of Sludge = 1.12), what is the approximate sludge age, ?c, in this system?
suppose there are 10 pieces of paper in a hat. Each piece of paper has a digit 1 through 10 written on it. Each number is written only once. You reach in the hat and select a piece of paper. What is the probability that the paper has either a 3 or..
What is the main difference between the calculation of deflections for reinforced and prestressed concrete beams
A 1.50 L buffer solution is 0.250 M in HF and 0.250 M in NaF. Calculate the pH of the solution after the addition of 0.0500 moles of solid NaOH. Assume no volume change upon the addition of base. The Ka for HF is 3.5 x 10 -4 .
The steel uniform shaft has four pulleys attached to it and frictionless bearings at its ends. The pulley at B is connected to a motor that is driving the system. The other three pulleys are consuming the power delivered by Pb .
A rod was held on point B and the telescope is inclined so that the horizontal cross line of the transit intersects the rod at the 5.2 ft mark.If the reading on the vertical limb of the transit was +25° 19’, what was the difference in elevation betwe..
Electromagnetic radiation may be treated from the classical or the quantum-mechanical perspectives. Briefly compare these two viewpoints.
The wedge is used to level the member. Determine thehorizontal force P that must be applied to move the wedge to theright. The coefficient of static friction between the wedgeand the two surfaces of contact is ts=.25.
Air at 70 degrees Celsius and atmospheric pressure flows with a velocity of 22 fps through a 3-in diameter pipe (e=0.00015 in). Find the friction head loss in 75 ft of pipe.
estimate the velocity with which you would contact the ground if you jumped from an airplane at an altitude of 500ft and a) air resistance is negligible, b) air resistance is important, but you forgot your parachute
A short Reinforced Concrete column is 300mm x 400mm. It is required to carry an ultimate load of 1500kN and an ultimate major axis bending moment of 300kNm. Calculate the area of reinforcement required.
A 0.3-m diameter pipeline terminates in a nozzle of outlet diameter = 0.15 m. When water flows through this pipe at a rate of 0.25 m3/s, the force required to hold the pipe (N) is most nearly.
What thickness of HMA would be required to carry the same traffic (computed in B) if there is a loss of serviceability due to frost heave of 0.8? Assume that the thickness other two layers would not be changed.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd