Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Water is flowing from a higher to a lower reservoir through a 24-inch pipe that has a Darcy friction factor of 0.02. The local loss coefficients for the bends, entrances, and exits sum to 3.5. The pipe connecting the two reservoirs is 5000 feet long, and the reservoirs differ in elevation by 100 feet. What is the flow rate in cfs from the higher to the lower pipe? A pump which runs at 80% efficiency, is available to pump water back from the lower to the higher reservoir at a velocity of 1.0 f/s. What power (in Horsepower) must be supplied to this pump?
A tangent section of highway has a -1.0% grade and ends at station 4+75 and elevation 82 ft. It must be connected to another section of highway that has a -1% grade and that begins at station 44+12 and elevation 131.2 ft.
The pressure at the entrance of the system must be at least 75 psi and the demand is 1350 GPM. The pipe material is to be riveted steel and the length of pipe is 5,000 feet. What size pipe should be used
Estimate the weight of concrete in a four-lane highway segment that begins as a 3% grade climb from 1000 feet altitude to 4000 feet and then a 6% downgrade to 2500 feet
A pile group consist of four piles in cohesive soil. Each pile's diameter is 0.4 m, and center to center spacing is 1.2 m. The ultimate capacity of each pile is 300 kN. Estimate the design capacity of the pile group, using a factor of safety of 2
Lines of levels were run requiring n instrument setups. If the rod reading for each backsight and foresight has a standard deviation δ what is the standard deviation in each of the following level lines?
Determine the quantity of lime and soda ash required to soften 1 mgd of the following water. Plan to achieve a hardness of 40 mg/L as CaCO3. Note that an excess of 35 mg/L of lime (CaO) is required to achieve 40 mg/L as CaCO3.
a spherical pressure vessel has an outer diameter of 10 ft and a wall thickness of 0.5 in. knowing that for the steel used ?all= 12 ski, E= 29 x 10^6 psi, and v= 0.29, determine (a) the allowable gage pressure,
Calculate the compressive stress (in psi) for a 6-in diameter by 12-in high concrete test specimen if the total deformation under load is 0.015 in. Calculate the total load on the test cylinder stress.
Assume the microorganisms are 55 percent efficient at converting food to biomass, the organisms have a first-order death rate constant of 0.05/day, and the microbes reach half of their maximum growth rate when the BOD5 concentration is 10 mg/L
How far apart must two 18 m diameter tanks be placed such that their stress overlap is not greater than 10% of the contact stress at depths of 10, 20, and 30 m
After moving the bubble four divisions off center, the reading is 1.410 m. For 2-mm vial divisions, what is (a) the vial radius of curvature in meters and (b) the angle in seconds subtended by one division
A river is 6m deep. The riverbed material has a saturated unit weight of 19.5kN/m3. What is the effective vertical stress 12m below the water surface. Assume the water is static and assume a datum at the water surface.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd