What fraction of the flue gas stream can be bypassed around

Assignment Help Civil Engineering
Reference no: EM13528827

A coal-fired power plant with an scrubber has an overall  removal efficiency of 85%. But rather than treat the entire stream to 85% removal, it has beenproposed to treat part of the flue gas to 95% removal, and tobypass the remainder of the gas. If the reblended stream muststill satisfy the overall removal requirement of 85%, what fraction of the flue gas stream can be bypassed around the scrubber?

Reference no: EM13528827

Questions Cloud

Compute the elevations at 100-ft stations throughout the : A 800 m vertical curve joins a -3% grade line to a 5% grade line. The PVI of the curve is at station 6200 and its elevation is 600.6 ft. Compute the elevations at 100-ft stations throughout the curve.
Determine the torque needed to turn the impeller : A centrifugal pump is used to pump water from ariver. The absolute velocity V2 = 82ft/s is at an angle of 25 degrees to theradial direction. The impeller's thickness is of 1.2 in and r2= 0.86 ft and rotates at a speed of 1250 rpm.
What is the maximum pressure on the form in psf : What is the maximum pressure on the form in PSF?
If the desired flowrate is at least : Two reservoirs, which differ in surface elevation by 40m, areconnected by 350m of new pipe of diameter 8cm. If the desired flowrate is at least 500N/s of water at 20 degrees C. can the pipematerial be made of
What fraction of the flue gas stream can be bypassed around : A coal-fired power plant with an scrubber has an overall  removal efficiency of 85%. But rather than treat the entire stream to 85% removal
What will be the value of xafter executing the above switch : If x = 3, then what will be the value of xafter executing the above switch statement?
Alsogive the parameter rating in each of the fiveclasses : Giving the classes, explain how rocks are put intofive (5) classes by each of the above parameters. Alsogive the parameter rating in each of the fiveclasses. Hint; use a table to answer this question
Discuss the applicability of grouting technology inimproving : Rock masses that donot have the desired properties for a givencivil engineeering application are improved. The method of choicedepends on the purpose for which the rock mass is intended. amongthe common methods for increasing the strength of fissured..
Explain each of the parametersin the equation is obtained : According to barton(1974) the quality of a given rock mass can bedetermined using the equation below. explain each of the parametersin the equation is obtained.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What will be the force in newtons required

A lunar module weights 1500 kg on earth where g = 9.75 mps2. On the surface of the moon where g = 1.70 mps2, what will be the force in Newtons required to accelerate the module at 10 mps2?

  Describe what is the maximum acceptable internal pressure

of 2640 psi with a factor of safety of 2.0 with respect to yielding. the yield stress of the steel is 65,000 psi in tension and 32,000 psi in shear. the diameter of the tank is 7.0 in. the minimum required wall thickness is 0.289 in.

  What does flattened mean for engineering and for managers

Thomas Friedman's bestseller, The World is Flat, says that the world has been, in his words, "flattened" or leveled which increases accessibility and competition worldwide. What does this mean for engineering and for managers who deal with enginee..

  Describe does the sample meet the niosh standard

The National Institute for Occupational Safety and Health (NIOSH) sets standards for CCl4 in air at 12.6 mg/m^3 of air (a time average over 40 hr). The CCl4 found in a sample is 4800 ppb. Does the sample meet the NIOSH standard

  What is the area of longitudinal steel required for column

A short concrete column is being used to support the roof over a pedestrian walkway. The unbraced column length is 9 feet and supports a dead load of 12 kips and a live load of 20kips.

  Determine the drawdown after 2 days of puming

a well is located in a confined aquifer. the transmissivity of the aquifer is 1200 m^2/d and the storativity is 0.0005. the flow rate is 4000 m^3/d. At a distance 75m from the well,

  Determine the normal stress in the rails at a temperature

Determine the normal stress in the rails when the temperature reaches 48oC assuming that the rails (a) are welded to form a continuous track (b) are 10m long with 3 mm gaps between them.

  Pressure on the soil if theta is given

A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees? Assum..

  What authority does responsible party have to verify

Who is responsible for verifying that the construction of the building complies with the hurricane protection provisions of the building codes What authority does the responsible party have to verify such compliance

  Calculate minimum set-back distance required for highway

Calculate the minimum set-back distance required for a national highway of 4 lane divided carriageway having circular curve of radius of 350 m & design speed 100 km/hr.

  Determine solids retention time and cell wastage flow rate

Using the following assumptions, determine the solids retention time, the cell wastage flow rate, and the return sludge flow ratefor the Jambalaya shrimp processing plant WWTP

  Formulate problem as an ip and find optimal solution

The Record-a-Song company has contracted with a rising star to record eight songs. The sizes in MB of the different songs are 8, 3, 5, 5, 9, 6, 7, and 12, respectively. Record-a-Song uses two CDs for recording. Each CD has a capacity of 30 MB.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd