What considerations would made with regards to cement type

Assignment Help Civil Engineering
Reference no: EM13309611

You are a construction engineer working on a large concrete foundation project, involving the placement of over 500,000 c.y of concrete. The construction site is adjacent to a salt-water source (bay) & it is decided to set up a concrete batch plant on site. The project schedule shows that the various concrete pours are to take place from April to September. 

What considerations would you make with regards to cement type, aggregate, water quality, and admixtures?

Reference no: EM13309611

Questions Cloud

What is partial pressure of each gass componet at 25 degrees : A 1-m^3 volume tank contains a mixture of 18.32 moles of oxygen, 16.40 moles of Nitrogen, and 6.15 moles of carbondioxide. What is the partial pressure of each gass componet at 25 degrees
Define the intiala rates at various substrate concentrations : The intiala rates at various substrate concentrations for an enzyme-catalyzed reaction are as follows.
What is the change in voltage : a 4.0x10^6 ohm resistor is connected in series with a 0.50 microfarad capacitor. What is the change in voltage between t=RC and t=3RC
Complete the pro- jected available balance : The Shades Sunglass Company assembles sunglasses from frames
What considerations would made with regards to cement type : You are a construction engineer working on a large concrete foundation project, involving the placement of over 500,000 c.y of concrete. The construction site is adjacent to a salt-water source (bay) & it is decided to set up a concrete batch plan..
Compute the capacitance of this combination : Two thin-walled concentric conducting spheres of radii 5.0 cm and 10 cm have a potential difference of 100 V between them
Define what is the concentration of the reactant b : A certain second-order reaction (B-product) has a rate constant of 1.25×10?3M^-1s^-1 at 27 degree celcius and an initial half-life of 264s . What is the concentration of the reactant B after one half-life
Determine which borrow site is the most economical : A new development is to be constructed in Mexico City. Due to the large subsidence, the elevation at the proposed site must be raised prior to construction. The total volume of soil needed to raise the site is 100,000 cubic yards.
What information do you need to find the selling price : To make a profit, the prices of the items sold in a furniture store are marked up by 60%. Design an algorithm to find the selling price of an item sold at the furniture store. What information do you need to find the selling price?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Rate of change in volume

A water tank has a height of 120m, and its area of cross-section is 2000m. Water is released from the tank and the water level drops by 1 meter every minute. Find the rate of change in volume.

  Calculate available water capacity

given bulk density as 1300kg/cubic meter and field capacity as 22% by weight and permanent wilting point as 10% by weight calculate available water capacity.

  What is the main objective of nasas mars science laboratory

Q. What is the main objective of NASA's Mars Science Laboratory (MSL) mission? When was it launched and when and where is it scheduled to land on Mars? Explain the major differences between this mission and Mars Exploration Rovers (MER) mission?

  Determine how long should the basin be

Assume Stoke's Law holds true for the following question. You are asked to desgin a settling basin. Flow rates are 16 million gallons/day. The basin must be 4m deep, and 4m wide. Particle size ranges from 0.2-50 mm in diameter.

  Determine what is runoff coefficient in a basin located

What is the runoff coefficient in a basin located near the middle of the climatic spectrum, with annual precipitation P = 32 in, ecosystem evapotranspiration ET = 22 in, and baseflow U = 3 in

  Find length and width of square basin for virus disinfection

Find the length and width of a square basin for virus disinfection of a flow of 6 MGD. You may assume a depth of 5 ft, a C•t product of 10 (mg/L) •min for 1.5-log removal, and a target free chlorine residual of 0.6 mg/L.

  Direction of flow in a conical tube

A conical tube of length 8 m fixed vertically with its smaller end upwards. The velocity head and pressure head at upper ends are 1.27 m and 2.50 m respectively.

  Determine what is steady state effluent concentration of si

Water flows into and out of a 5 liter tank at a rate of 1 L/min. Within the tank, the mineral apatite is dissolving at a rate of 3x10^-10 moles of Si per m^2 per sec. If the tank contains 10g of the apatite with a specific surface area of 2 m^2/g,

  Why is wood more common in residential construction in us

why is wood more common in residential construction in the US and concrete more common in commercial construction

  Determine the velocity of slider block

Knowing that at t= 3s slider block C has moved 57 mm to the right, Determine the velocity of slider block C at t=0, (b) the acceleration of A and C, (c) the change in position of block A after 5s.

  Determine angular acceleration and velocity of the link

Peg P is driven by the fork link OA along the curved path described by r = (2*theta) ft. At the instant theta = pi / 4, the angular velocity and angular acceleration of the link are (theta-1dot) = 3.0 rad/sec and (theta-2dot) = 1.1 rad/sec^2

  Calculate the required plate area and the number of plates

An Electrostatic Precipitator must treat 500,000 acfm with 99% efficiency. Assuming an effective drift velocity of 0.4 ft/sec, calculate the required plate area in ft^2, and the number of plates if each is 20 ft tall by 10 ft long, and there are 4..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd