Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Let c(x) = 1 - x2/2! + x4/4! and s(x) = x - x3/3! + x5/5! be approximations to cos(x) and sin(x) respectively. What are the relative and absolute errors in using these formulas for x = -2, -1, 0, 1, 2 degrees?
Signal w(t) is input to the filter. This signal is white noise, with PSD = N0/2. If we denote the filter output as n(t), what is the power in n(t) We input v(t) + w(t) into the filter, where v(t) = Ac cos(2pif0t). If Ac=4, what is the output signal..
Filament 1 is on the left, filament 2 is in the middle, and filament 3 is on the right. Filaments 1 and 2 have currents of 1 A in the ba z direction, and filament 3 has a current of 2 A in the ba z direction
Clearcly, any noise will pass straight through to the ADC subsystem, introducing measurement error. You have two choices to mitigate this: SW filtering and HW filtering. Assume the uC sample rate, Fs, is 100 Hz with 8 bit resolution.
The charge carried by an electron is ?1.60×10?19 C. Suppose that an electron moves through a voltage of 120V from the negative polarity to the positive polarity. How much energy is transferred Does the electron gain or lose energy
First as the output stage use a Zener shunt regulator and then replace the Zener shunt regulator with an appropriate IC voltage regulator. Do the SPICE simulation of the whole circuit, which has the Zener shunt regulator as the last stage.
A semiconductor, in thermal equilibrium, has a hole concentration of p0 = 2x1016 cm-3. The minority carrier life time = 3x10-7 s. (Assume, ni = 1010 cm-3)
Compare a lumped element model of a lossless transmission line (single L and C) with the distributed model. Use the following values for the transmission line in this comparative analysis.
Compare the field at the center of a Helmholtz coil pair and at the center of a solenoid, if both use the same total length of wire and carry the same current.Take the solenoid length equal to the spacing between the Helmholtz coils
If you are asked to build an 8 bit odd parity generator/ checker with the output ERROR=1. when there is a 1 bit error, which type of gates, XOR or XNOR is simpler to use Explain
A simple voltmeter with a full-scale reading of 50(V) is required. Use a d'Arsonval movement with a rating of 20(mV) at 1 (mA). Calculate the value of the voltmeter resistor, Rv, required to achieve these design specifications.
A telecommunication system has a link bandwidth of 10 MHZ, signal propagation of 3.5 x 10^8 m/s, transmitting as 1500 frames per minute, with 15000 bits per frame, over a distance of 100 km. What is the bandwidth-delay product?
g. What happened to all the power delivered to the resistors h. If the resistors are available with wattage ratings of 1/2 W, 1 W, 2 W, and 5 W, what minimum wattage rating can be used for each resistor
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd