What are the northing and easting coordinates for station

Assignment Help Civil Engineering
Reference no: EM13315730

The coordinates for station A are 1023.34 N and 988.56 E. What are the northing and easting coordinates for station B that is located 40 feet due east of A, and 22.32 feet due south of A

Reference no: EM13315730

Questions Cloud

What is the focal length of the combination : A converging lens with focal length of 11.8 cm is placed in contact with a diverging lens with a focal length of 21.1 cm. What is the focal length of the combination
Calculate the dry unit weight of five standard proctor : The water content in one of five standard Proctor test samples is 15.2%. The corresponding degree of saturation is 85%. Calculate the dry unit weight if Gs=2.67
What is the average power dissipated by the circuit : A series RLC circuit has R = 50 %uF057, L = 2.7 %uF06DH, and C = 52 nF. What is the average power dissipated by the circuit
Determine the wavelength of the standing wave : a standing wave is in a open-end tube as shown. the tube legth is L = 1.80m. determine the wavelength of the standing wave
What are the northing and easting coordinates for station : The coordinates for station A are 1023.34 N and 988.56 E. What are the northing and easting coordinates for station B that is located 40 feet due east of A, and 22.32 feet due south of A
What is its change in length : A steel section of the Alaskan pipeline had a length of 55.5 m and a temperature of 19.0 deg C when it was installed. What is its change in length
How the gravel will be scoured by the flowing water : The trapezoidal channel has a slope of .004. The sides of the canal are sealed with a plastic membrane, which is protected by a 1 ft thick layer of 1 in diameter gravel. The bottom is a 6 in slab of rough concrete.
What escape speed is needed for a space ship : The planet mars hass a mass of 6.42x10^23kg and a radius of 3396km. What escape speed is needed for a space ship leaving the surface of Mars
What is the average change in momentum : In 13.6 s, 220 bullets strike and embed themselves in a wall. What is the average change in momentum per second for the bullets

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate critical depth and critical slope in an earth-line

A flow of 28 m3s-1 occurs in an earth-lined canal having a base width of 3 m, side slopes of 1(vertical) to 2 (horizontal) and the Manning's n value of 0.022. Calculate the critical depth and critical slope.

  Four-lane freeway problem

A four-lane freeway (two lanes in each direction) is on mountainous terrain with 11-ft lanes, a 5-ft right-side shoulder, interchange spacing of one every 10 miles, and a 60-mi/h base free-flow speed.

  Discuss about damp-proofing trenches

Discuss about damp-proofing trenches

  Determne the diameter of the tube at a uniform rate

A 25 mm diameter steel cylinder falls under its own weight at a uniform rate of 0.1 m/s inside a tube of slightly larger diameter. Castor oil of viscosity 0.25 N.s/m2 fills the spacing between the tube and the cylinder.

  Find the average time in system

If the time required to pay for parking is exponentially distributed with a mean of 15 seconds, find the average time in system.

  Find shear stress on each bolt and bearing stress on the bar

Due to an error, the length L shown was 1.795 m instead of 1.80 m, thus there is a gap of 0.5 cm, which makes it difficult to bolt the bar on the structure. The engineer suggests the bar is heated up by - Delta in order to close the gap.

  What distance will shoreline recede at the lake shore slope

Lake Pleasant, AZ, has a surface area of approximately 2,000 ha. The inflow for the month of August is zero. The lake is dammed so that no water leaves the impoundment downstream of the dam. There is no rain in August.

  What is the empirical formula of aluminum oxide

{rm Al} reacts with 4.45 {rm g} of {rm O}_{2}, what is the empirical formula of aluminum oxide?

  Define two types of classifiers mostly used in data mining

Two types of Classifiers mostly used in Data mining. Other than Naive Bayes and decision trees, pick two other types of classifiers and discuss how they work

  Find the flow rate per unit thickness for a section midway

Two piezometers are located 1000 ft apart with the bottom located at depths of 50 ft and 350 ft, respectively, in a 400-ft-thick unconfined aquifer. The depth to the water table is 50 ft in the deeper piezometer and 40 ft in the shallow one.

  Find the maximum shearing stress and its location

Find the maximum shearing stress and its location in the shaft and the angle of twist of A with respect to C. Let G = 4x10^6 psi for the entire shaft.

  Define need before function

Which of the following is not a basic systems engineering concept?a. Define need before function

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd