Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. A heat engine receives 1 kW heat transfer at 1000 K and gives out 400 W as work, with the rest as heat transfer to the ambient. Find its first and second-law efficiencies.
2. A heat exchanger increases the exergy of 3 kg/s water by 1650 kJ/kg using 10 kg/s air coming in at 1400 K and leaving with 600 kJ /kg less exergy. What are the irreversibility and the second-law efficiency?
if a pipeline is horizontal, what is the porportion of the potential energy head at the upstream crossection that is changed to kinetic energy head at the downstream crossesction
A 780-g mass is attached to a vertical spring and lowered slowly until the mass rests at its equilibrium position 30 cm below the original length of the spring. It is then set into simple harmonic motion of amplitude 5 cm.
Problem: A 24F-V4 Douglas Fir-Larch glulam is used to span 32 ft, carrying an ASD load combination (D+S). The load is uniform over a simple span, and the beam is laterally supported so that lateral torsional buckling is prevented.
A light rail route has 2 terminals and 4 intermediate stations. The demand (passengers/hr) for morning peak hour is: North Terminal Station 1 Station 2 Station 3 Station 4 South Terminal
Intrinsic factor, which is made by the stomach, must be present forthe body to absorb Vitamin B12 How might the absence of intrinsic factor affect the bones of a patient?
Using a steel with Fy = 50ksi, whatuniformaly distributed service load can a simple supported W33 x118 carry for a span of 40 ft when (a) the compression flange isbraced laterally for its full length, and (b) lateral bracing issupplied at the ends on..
A large parabolic antenna is designed against wind load. During a wind storm, the maximum wind-induced pressure on the antenna, P, is computed as P= 1/2CRV^2 Where C = drag coefficient, R = air mass density in slugs/ft3, V = maximum wind speed in ft/..
How are the requirements for software determined? What are some of the measures/ metrics for software? How is software reliability measured? How is software maintainability measured?
A tank contains 0.05 m^3 of nitrogen gas at -21 C and 10 MPa. Determine the mass of nitrogen, in kg, using: a) the ideal gas model b) data from the compressibility chart Comment on the applicability of using the ideal gas model for nitrogen at thi..
Compute the required layout distance if the Temperature is 13 degrees celcius, Tape Length is 29.990 m, and the required Layout distance is 500.000 m.
This 140 lb gymnast supports himself with arms stretched out in the iron-cross position shown. Say the arms each weigh 10% of the body weight (and have approximately uniform distribution of mass), and that each ring exerts only an upward force on ..
Two channel cross sections are proposed. Assume slope, cross sectional area, and surface type are constant for each channel. Which cross section option will provide the highest flow rate? Show calculations.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd