What are the critical methods of the paper

Assignment Help Chemistry
Reference no: EM131282068

You must read the paper assigned to you, and then write a two-page typed report (1.5 SPACE) by answering the following questions below. The information requested you may find it in the various parts of the paper, which may not be in the same sequence as the questions. In each paper, depending on the journal, these questions may be covered at different places or even at the end of the paper or in some cases some parts may be joint together.

You should not number your answers and you do not have to answer these in the exact order indicated below. Try instead, to incorporate the answers in proper sentences as if you were describing the scientific work to someone else.

You must hand in your assignment electronically and in a hard copy as well as you must submit a hard copy of the literature paper you have used. Assignments should be handed in by the 21st of Nov the latest. Late assignments will lose 5 points/day.

1. Introduction and Background:
What hypotheses are being tested in this paper?
What information induced the authors to perform the experiments?
What new methods or insights brought to bear on the problem?

2. Methods:
What are the critical methods of the paper?
What enabling technologies are used?
What are the weaknesses of the methods used?
Are there other or better approaches that could be used?
If this is a genetics approach, what would be a biochemical or molecular approach?
If this is a biochemical or molecular approach, what genetics methods could be used?

3. Results and Discussion
What are the primary conclusions of the paper?
Did the authors prove their hypotheses?
What novel information or directions come from this work?
What control experiments were performed?
What assumptions still remain in the work?
How could these assumptions be tested?
What other explanations for the observations are still possible?

Reference no: EM131282068

Questions Cloud

Find the spectrum of the signal : Find the spectrum of the signal s(t) that results from the use of natural sampling; you may assume that time t = 0 corresponds to the midpoint of a rectangular pulse in c(t).
What is its surface temperature at that point : The sphere diameter is 1 cm, and it rises through the bath at 1 m/s. How far will the sphere rise before its center temperature is 300°C? What is its surface temperature at that point? (The sphere has a thin nickel plating to protect the copper fr..
How the sampling theorem can be applied : Describe how the sampling theorem can be applied in the frequency domain.- Describe how the sampling theorem can be applied in the frequency domain.
How i envision the scholarship will impact me personally : How I envision the scholarship will impact me personally and my future as a public servant, and My experiences and perceptions about agriculture, food, and natural resource science.
What are the critical methods of the paper : BIOL-491 Research Project What information induced the authors to perform the experiments and what new methods or insights brought to bear on the problem?
What could you add to make it more dynamic : What would you identify as specific learning outcomes from this workshop?What specific strategies or techniques will help deliver those outcomes?How well do the "bones" of this workshop encourage active learning? What could you add to make it more dy..
How many cases of bags should the store order : How many cases of bags should the store order each time if we want to select the lowest total annual cost strategy (ordering cost plus holding cost plus material acquisition cost)?
Estimate the total heat transfer coefficient : Calculate the average convection heat transfer coefficient when the droplet has reached its terminal velocity. Assume that the water is at 50°C and the air is at 20°C. Neglect mass transfer and radiation.
Determine and sketch spectrum of resulting pam signal : Figure shows the idealized spectrum of a message signal m(t).- Determine and sketch the spectrum of the resulting PAM signal.

Reviews

Write a Review

Chemistry Questions & Answers

  Explain p-toluenesulfonic acid as a catalyst

Show the mechanism for the aldol condensation product of phenyl acetaldehyde with p-toluenesulfonic acid as a catalyst.

  Explain the ph of the solution when half of the base

What is the pH of the solution when half of the base in part a has been added. What is the pH of the solution at the equivalnce point

  Unknown metal to the hcl solution

If a student used an iron scoopula, instead of a plastic one, to add the unknown metal to the HCl solution, will it affect the calculated molar mass of the unknown metal? If so, how? Justify your answer with an explanation.

  Explain earth''s current atmospheric load of co2

If all of these tires were burned with complete efficiency, by how much (in tonnes) would Earth's current atmospheric load of C02 increase

  State solutions of regularly decreasing concentrations

One way to make a set of solutions of regularly decreasing concentrations is to make serial dilutions of the most concentrated one. a. starting with

  Explain reach the end point of the reaction

A 0.4512 g sample of a primary-standard-grade Na2CO3 required 36.44 ml of a H2SO4 solution to reach the end point of the reaction.

  More strong base is added until the equivalence point is

a solution is made by mixing 9.00 mmol of a weak acid and 3.00 mmol of the strong base. what is the resulting ph? more

  Calculate mass of ccl4

calculate mass of CCl 4 that  formed if 1.5 moles of CH 4 react with 1.4 moles of Cl?

  How many calories are used to heat

how many calories are used to heat a 50g sample of water from 8.1 degrees celius to 27.4 degrees celcius?

  What is the percent water by weight in this hydrate

An analysis showed that 25.0 g of this hydrate, CoCl 2 * 6 H 2 O, contains 11.3 g of water. What is the percent water by weight in this hydrate?

  Calculate the concentration of the naoh solution

A NaOH solution is standardized by titration with 0.835 g KHP (monoprotic standard acid, MW = 204.2 g/mol). 23.47 mL of the unknown NaOH solution is needed to titrate the 0.835 g KHP to the endpoint. Calculate the concentration of the NaOH solutio..

  A balloon filled with helium gas has a volume of 361 ml at

a balloon filled with helium gas has a volume of 361 ml at a pressure of 1atm. the balloon is released and reaches an

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd