What amount will accumulate at time of her retirement

Assignment Help Civil Engineering
Reference no: EM13539044

Salary 65000 per year, jane plans to retire in 25 years. Annual anticipated increaase is 3000 a year.

65000

68000

71000

she plans to deposite 5% of her yearly salery, into retirment fund that earns 7% intrest compounded daily. what amount will accumulate at time of her retirement?

Reference no: EM13539044

Questions Cloud

What is the precision of the work : The sides of a closed figure have been measured and found to have a length of 4133.64 ft. If the total error in the measurements is equal to .15 ft, what is the precision of the work?
How much energy is produced in this collision : Two comets, each of mass 6500 kg and traveling 95 m/s in opposite directions, collide head-on and come to rest. How much energy is produced in this collision
What error results from curvature and refraction : Successive plus and minus sights taken on a downhil line of levels are listed below. the values represent the horizontal distances between the instrument and either the plus or minus sights. What error results from curvature and refraction?
Determine the magnitude of the force on the roof : In a tornado or hurricane, a roof may tear away from the house because of a difference in pressure between the air inside and the air outside. What is the magnitude of the force on the roof
What amount will accumulate at time of her retirement : She plans to deposite 5% of her yearly salery, into retirment fund that earns 7% intrest compounded daily. what amount will accumulate at time of her retirement?
Calculate the fluid viscosity if the torque on the inner : For two 0.2 m long rotating concentric cylinders, the velocity distribution is given by u(r) = 0.4/r - 1000r m/s. If the diameters are 2 cm and 4 cm, respectively, calculate the fluid viscosity if the torque on the inner cylinder is measured to be 0...
Explain a stearic acid molecule consists of 18 carbon atoms : A stearic acid molecule consists of 18 carbon atoms linked together. Assuming that the thickness, t, of a monolayer is equal to the length of the stearic acid molecule, what is the size diameter of a carbon atom, s =t/18.
Research to develop a new computer game : Research to develop a new computer game.
What torque is required to drive the disk at 660 rpm if the : A disk spins within an oil-filled enclosure, having 2.4 mm clearance from flat surfaces each side of the disk. The disk surface extends from radius 12 to 86 mm. What torque is required to drive the disk at 660 rpm if the oil's absolute viscosity is ...

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the specfic work required in kj per kg

Saturated water vapor at 150 deg C is compressed in a reversible steady-flow device to 1000 kPa while its specific volume remains constant. Determine the specfic work required in kJ/kg. The heat transfer is not negligible.

  Velocity profile from the pipe wall

Compute points on the velocity profile from the pipe wall to the centerline of a 3/4-in Type K copper tube if the volume flow rate of water at 60 degrees F is .50 gal/min.

  Find the time taken for the depth to empty completely

a rectangular swimming bath is 1m deep at one end and increases uniformly in depth to 2.6m at the other end . the bath is 8m wide and 32m long and is emptied through an orifice of 0.2m^2 at its lowest point.

  Calculate the average stress in the plane of the reduced

A 1.0-in-diameter hole is drilled on the centerline of a long, flat steel bar that is 1/2" thick and 4" wide. The bar is subjected to a tensile load of 30,000 lb. Calculate the average stress in the plane of the reduced cross section and the maxium t..

  Determine the temperature rise that will cause joint to fail

the block is fitted between the fixed supports. if the glued joint can resist a maximum shear stress of T(allow)=2ksi, determine the temperature rise that will cause the joint to fail. Take E= 10(10^3)ksi, v=0.2

  Find the magnitude and direction of the hydraulic gradient

hree wells are drilled in an unconfined aquifer with the following coordinates and observed heads: Well 1: 0,200 (meters) 50 (meters) Well 2: 240,130 54 Well 3: 140, 320 63 (a) Find the magnitude and direction of the hydraulic gradient.

  Estimate value of emission rate divided by the wind speed

A ground level source is emitting pollution. An air sampler is located 1 km downwind and 0.5km crosswind of the source measures the concentration of the pollutant ant ground level as 10 micrograms/cubic meter.

  Determine the bearing of polaris is approximated by z

You are planning a Polaris observation at latitude 42 degrees North when the star is at or near upper culmination. You want to know the error in azimuth that will result from a 1 min timing error.

  Calculate the pressure inside a 2-mm diameter bubble

Calculate the pressure inside a 2-mm diameter bubble of water at 20°C and compare with the pressure inside a 2-mm diameter droplet of water at 20°C.

  Calculate the viscosity of the lubricating oil

A 4 in. in diameter shaft moves through a well-oiled sleeve that is 12 in. long. The force required to move the shaft is 25 lbf, and the shaft velocity is 5 in./s.

  On five-cycle semilogarithmic paper plot the grain size

on five-cycle semilogarithmic paper plot the grain size distribution curves from the following mechanical analysis data

  What length l of splice plate is needed

two strips of a plastics material are bonded together as shown. The average shearing stress in the glue must be limited to 1000 kpa. what length L of splice plate is needed if the axial load carried by the joint is 55 kN and the width (W) is 315 m..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd