Water that flows out of a pipe at constant pressure

Assignment Help Physics
Reference no: EM13543285

What happens to water that flows out of a pipe at constant pressure (or constant flow rate), and then enters a restriction in the pipe (goes from a fat pipe to a thin pipe, but the pressure in the fat part of the pipe stays the same:

a. it stays at th same pressure and velocity
b. the velocity goes up and the pressure goes down
c. the velocity goes down and the pressure goes up
d. the velocity goes up and the pressure goes up
e. the velocity goes down and the pressure goes down

Reference no: EM13543285

Reviews

Write a Review

 

Physics Questions & Answers

  What average force does seat belt exert on him

Pete slides a crate up a ramp with constant speed at an angle of 27 degrees by exerting a 133 N force parallel to the ramp. How much work has been completed against gravity when the crate is raised a vertical distance of 1.6 m? The coefficient of fri..

  Q1 a sling-thrower puts a stone 0250 kg in the slings pouch

q1. a sling-thrower puts a stone 0.250 kg in the slings pouch 0.010 kg and then begins to make the stone and pouch move

  Determine the angular acceleration of the wheel

A bicycle slows down uniformly from v0 = 8.40 m/s to rest over a distance of 115m. Each wheel and tire has an overall diameter of 68.0 cm. determine the angular acceleration of the wheel

  Obtain the magnitude of the average induced emf in the coil

To monitor the breathing of a hospital patient, a thin belt is girded around the patient's chest as in the figure below. The belt is a 160-turn coil. find the magnitude of the average induced emf in the coil during that time

  By what factor does the wave velocity change

The tension in a guitar string is increased by a factor of two. by what factor does the wave velocity change

  Find how much work is done in one cycle

A gas increases in pressure from 2.00 atm to 6.00 atm at a constant volume of 1.00 m3, How much work is done in one cycle

  What would be the rate of energy transfer

It is fairly easy to produce a static magnetic field of 0.050 T in the lab. If an EM wave could be produced with maximum magnetic field, B0=0.050 T, what would be the rate of energy transfer

  How long is the bullet in the target

Find out a formula for a electrical flux on a sphere for a point charge at the center of the sphere with a hole in the sphere.

  Calculate the total work done on the cube

A cube of iron, of side length 14cm, is heated from 10?C to 90?C; Calculate the total work done ON the cube and the change in internal energy of the cube

  Determine what is the final temperature of the engine

An internal combustion engine with an initial temperature of 36.2 is started. The coombustion reactions add 8.66 x 10*6 J of energy as heat to the engine after several cycles. what is the final temperature of the engine

  What are the accelerations in the x and y directions

After the horizontal projectile leaves the gun, what are the accelerations in the x and y directions

  What is the probebility of the particle

for a particle in a one demention box, the ground state wave function is: psi=(2/L)^1/2 sin(piX/L), What is the probebility that the particle is in the right-hand half on the box

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd