The water temperature can be assumed to be 60 degrees

Assignment Help Civil Engineering
Reference no: EM13542308

1.A 17ft long kayak moves with a speed of 5 ft/s. Would a boundary layer type flow be developed along the sides of the boat? Explain. The water temperature can be assumed to be 60 degrees F.

2.The Einsten's equation is dimensionally homogeneous. determine the dimensions of E if V is velocity and m mass.

3.A rectangular channel (n=0.015) is 6.0 m wide with a discharge rate of 60 cms and a longitudinal slope of 0.01. What is the expected depth of flow in the channel?

4.A gunite concrete trapezoidal channel with 1:2 side slopes, as ilustrated below, conveys 60 m3/s on a slope of 0.0005. Compute the depth of flow.

Reference no: EM13542308

Questions Cloud

How long would the electric heater run that night in the : A passive solar house that is losing heat is outdoors at an average rate of 50,000 kJ/h is maintained at 22oC at all times during a winter night for 10h. the house is to be heated by 50 glass containers each containing 20 L of water this is heated to..
The temperature of the gas remains constant during the : A vertical 12-cm diameter piston-cylinder device contains an ideal gas at the ambient conditions of 1 bar and 24oC. initially the inner face of the piston is 20 cm from the base of the cylinder
Nitrogen remain in thermal equilibrium during the process : A steel cylinder initially contains nitrogen gas at 200kPa and 25oC. the cylinder is connected to a suply line containing nitrogen at 800kPa and 25oC. A valve is opened, allowing nitrogen to flow into the cylinder until the pressure reaches 800kPa. T..
Water heater that consists of an insulated pipe : It's proposed to have a water heater that consists of an insulated pipe of 5-cm diameter and an electric resistor inside. Cold water at 20oC enters the heating section steadily at a rate of 30L/min
The water temperature can be assumed to be 60 degrees : A gunite concrete trapezoidal channel with 1:2 side slopes, as ilustrated below, conveys 60 m3/s on a slope of 0.0005. Compute the depth of flow.
Will the quantity of coarse aggregate increase decrease : A concrete mix with a 3-inch slump, w/c ratio of .50, and sand with a finesse modulus of 2.4 contains 1700 lb/yd^3 of coarse aggregate per cubic yard. To adjust the mix so as to increase the compressive strenght
Describe how edge dislocations move under an applied : In the context of JCT 2005, to what extent can a subcontractor negligently set fire to an existing building with impunity?
When the pressure in the tank reaches the valve is closed : Steam at 800 kPa and 300 C is bled off from a large supply line, passed through a valve, and allowed to enter an initially evacuated, uninsulated tank with a volume of 0.3 m3.
Apply corrections for temperature pull and sag to determine : What is the water content and liquidity index of the fines in compacted mass?A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Derive an expression for small flow rates over a spillway

Use dimensional analysis with the following parameters: height of spillway (P), head on the spillway (H), viscosity of liquid, density of liquid, surface tension, and acceleration due to gravity.

  Calculate softening chemicals required in pound per milllion

given data of water softened by excess lime treatment, sketch a meq/l, calculate the softening chemicals required in pounds per million gallons, and draw a bar graph for the softened water after re-carbonation and filtration

  What is the required detention time and tank

A chlorination process is to be used to disinfect a wastewater treatment plant effluent. The plant treats 1.8MGD (million gallon per day). The water entering this unit has about 4500mg/L of coliforms, and the effluent target is 0.1 mg/L of coliforms.

  Determine station of pvc and pvt and design speed of curve

An equal-tangent crest vertical curve connects a +3.2% and -1.1% grade. The PVI is at station 98+20. Due to drainage considerations, the highest point of the curve is at station 100+79.35.

  Maximum volume of treated wastewater

Roughly what is the maximum Volume of treated wastewater should you put in the bottle if you want to have at least 2.0mg/l of DO at the test (filling the rest of the bottle with the water

  Estimate particle size will be collected with efficiency

A cyclone is designed with an inlet width (W) of 12.0 cm and has four effective turns. The inlet gas velocity is 15.0 m/s and the particle density is 1.70 g/cm3. (a) Estimate the particle size that will be collected with 50 % efficiency.

  Problem related to horizontal cylindrical tank

A horizontal cylindrical tank 4 ft in diameter and 10 ft long is full of water. Find the work done in pumping the water to a point 4 above the top of the tank.

  Determine the size of pipe for a water temperature

The difference in water level is 60ft. Determine the size of pipe for a water temperature of 60 degrees Fahrenheit. Apply The Darcy-Weisbach equation.

  What would you suggest in terms of population size and yield

A lake has a carrying capacity of 12,000 fish. At the current level of fishing, 3,000 fish per year are taken with the catch uniformly distributed throughout the year.

  Determine the length of the swale required with side slopes

The longitudinal slope of the swale is to be 1.5% with side slopes of 5:1 (H:V). If the grassed swale has a Manning's n of 0.030 and a minimum infiltration rate of 200 mm/hr, determine the length of the swale required.

  Find the magnitude of the force on one side of the plate and

A rectangular plata 5 ft by 4 ft is at an angle of 30 degrees with the horizontal, and the 5-ft side is horizontal. Find the magnitude of the force on one side of the plate and the depth of its center of pressure when the top edge is 1 ft below the w..

  Determine the force needed in each of the two springs

The door of an oven has 27.9lb weight that acts vertically through point D. The door is supported by a hinge at point A and two springs that are symmetrically located on each side of the door.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd