The pump is located close to the pipe entrance at the lower

Reference no: EM13546691

Water from a lower reservoir (water surface elevation) 500 m is pumping to the upper reservoir (water surface elevation 600 m) through a 5000 m long straight pipe with 0.5 m diameter. If the flow rate is 1m3/s, calculate head supplied by the pump. Draw HGL and EGL for the system. Assume the water depth in the lower reservoir is 5 m and the depth in upper reservoir is 10m. The pump is located close to the pipe entrance at the lower reservoir.

Reference no: EM13546691

Questions Cloud

What are the inputs needed to determine stress a polymer : What are the inputs needed to determine stress a polymer with a fixed end on one side, and the other with a tension force of 50,000 lbs a year after the load is applied?

Compute the maximum horizontal shear stress at the neutral : A solid rectangular simply supported timber beam 6 in wide, 20 in deep, and 10 ft long carries a concentrated load of 16,000 lb at midspan. Use nominal dimensions.

Estimate the settlement of the footing four years after : A proposed square footing 2 meters by 2 meters carrying a total load of 800 kN is to be constructed on a sand deposit. The depth of the footing will be 1 meter below the ground surface

Prepare the t-accounts and journal entries : Prepare the T-accounts for raw materials inventory, work in process inventory, finished goods inventory, manufacturing overhead, and cost of goods sold. Don't forget to enter the beginning balances in the inventory accounts.

The pump is located close to the pipe entrance at the lower : Water from a lower reservoir (water surface elevation) 500 m is pumping to the upper reservoir (water surface elevation 600 m) through a 5000 m long straight pipe with 0.5 m diameter

Calculate the distance the tank has moved when the water in : Use appropriate kinematics equations (for the right ranges) for the new velocity and distance traveled. (Hint: when the impulse becomes a non-negative number set it to zero; then the acceleration becomes zero and the velocity does not change; so use ..

Why was the specific weight of water used to find the head : A beam must carry a total factored bending moment of 1062kN-m. It has a maximum beam effective depth of 25in. Design the beam in US customary units using f’c=4ksi and fy=413.4MPa. If necessary use d’=2.5in. Assume an exterior exposure according to AC..

Determine the tension in each of the cables at a time when : A long trough is supported by a hinge along its lower edge and a series of horizontal cables attached to its upper edge. Determine the tension in each of the cables, at a time when the trough is full of water.

Determine the design speed of the curve : An egual-tangent sag vertical curve is designed with the PVC at station 109+00 and elevation 950 ft, the PVI at station 110+77 and elevation 947.34 ft, and the low point at station 110+50. Determine the design speed of the curve.

User Account

All Pages