The mole fraction of water vapor in the air

Assignment Help Mechanical Engineering
Reference no: EM13711751

If the weather report says that it is 60°F outside, the barometric pressure is 28.50 in Hg, and the relative humidity is 85.0%, find the following values.

1) The partial pressure of water

2) The mole fraction of water vapor in the air

3) The dew point

4) The molal humidity

5) The absolute humidity

6) Percentage humidity

Reference no: EM13711751

Questions Cloud

A credential references : Write ethics reflection paper 6pgs with a credential references. Ethics in business.
Is triple-bottom-line accounting a reasonable approach : 3. Is triple-bottom-line accounting a reasonable approach to encourage businesses to take responsibility for the impact of their actions on social and environmental systems, or does it place an unrealistic burden on businesses to measure what may ..
Determine the mass flow rate of propane : A typical gas stove burner supplies a kettle filled with water at a rate of 15,000 Btu/hr with a flame temperature of 750C. The gas fed to the burner is composed of propane mixed with 10% excess air. The gas feed is initially at -20C and 1 bar and th..
What is the mole fraction of water in the exhaust stream : A mixture of propane and butane is fed into a furnace where it is mixed with air. The furnace exhaust leaves the furnace at 343°C, 780.0 mmHg and contains only N2, O2, CO2, and H2O. The partial pressure of O2 in the exhaust is 51.40 mmHg and the part..
The mole fraction of water vapor in the air : If the weather report says that it is 60°F outside, the barometric pressure is 28.50 in Hg, and the relative humidity is 85.0%, find the following values. The partial pressure of water. The mole fraction of water vapor in the air
Determine the rate of heat transfer in the heat exchanger : A heat exchanger is to heat water (Cp= 4.18 KJ/Kg.C ) from 25 to 60 C at rate of 0.2 kg/s. the heating is to be accomplished by geothermal water ( Cp= 4.31 KJ/Kg.c ) available at 140C at a mass flow rate of 0.3Kg/s. Determine the rate of heat transfe..
Coca-cola blak was introduce to various international market : Coca-Cola Blak was introduced to various international markets including the USA and discontinued in the US market in 2007. In this case you are to analyze a famous firm's product failure and in doing so demonstrate your understanding of a prom..
Determine the temperature at the compressor exit : Air is compressed from 14.7 psia and 60 F to a pressure of 150 psia while being cooled at a rate of 10 Btu/lbm by circulating water through the compressor casing. the volume flow rate of the air at the intel conditions is 5000 ft^3/min, and the power..
Composed of mutuality orthogonal unit vectors : Let A, B, C and D denote four reference frames, composed of mutuality orthogonal unit vectors ai, bi, ci and di (i=1,2,3), respectively. Assume that rotation matrices aRc, aRd and bRd are given. Let x, y, z and t denote some specified constants. Give..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Determine the radial acceleration of point on outer surface

Determine the radial acceleration of a point on the outer surface of the 36 inch diameter tires of a jet powered car traveling at 660mph.

  In a certain industrial dryer 4 kgh of water is to be

in a certain industrial dryer 4 kgh of water is to be removed from a moist material. the drying is accomplished by

  Determine the mass of the nitrogen stored in the tank

A fixed mass of nitrogen gas is stored in a cylindrical tank with an internal diameter of .45m and a length of 1.6m. The pressure and temperature of the nitrogen are 2MPa and 75 degrees Celsius. Determine the mass of the nitrogen stored in the tank.

  Consider installation on the bottom of the attic roof only

consider the attic of a home located in a hot climate. the floor of the attic is characterized by a width of l1 10 m

  A 1 ton car is climbing a 200 m long uphill road with a

a 1 ton car is climbing a 200 m long uphill road with a slope of 30deg from horizontal. what is the power required to

  Contained in a piston-cylinder device

The refrigerant R-410a is contained in a piston-cylinder device, as shown in the figure, where the volume is 13 L when the piston hits the stops. The initial state of the fluid is -30 °C, 150 kPa, with a volume of 10 L. The entire system is brought i..

  Cold cranking amperes of a conventional lead-acid

The cold cranking amperes (CCA) of a conventional lead-acid automobile battery is the amount of current the battery can provide at 0°F for 30 seconds and maintain at least 1.2 volts per cell (or 7.2 volts for a standard 12-volt battery). If a batter..

  An ideal air-standard closed brayton cycle operates between

an ideal air-standard closed brayton cycle operates between the pressures of 1 atm and p2. intake air to the compressor

  Newtons law to find the tension in the string

draw a free body diagram for each of the two situations. use the "radial" Newton's law to find the tension in the string at each of these situations.

  Calculate the mass in kg of oxygen that has been released

a 10 m3 oxygen tank is at 15 degree c and 800 kpa. the valve is opened and some oxygen is allowed to escape until the

  Assume the refrigerant is a saturated vapor at the

a vapor-compression refrigeration cycle employed in a heat pump uses refrigerant r-134a and provides 15 kw of heating.

  A person weighs 180lbs at sea level the radius of the

a person weighs 180lbs at sea level. the radius of the earth is 3960 mi. what force is exerted on the person by the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd