The final temperature in the tank in degrees celsius

Reference no: EM13545607

A rigid tank whose volume is 10L is initially evacuated. A pinhole develops in the wall, and air from the surroundings at 1 bar, 25 degrees Celsius enters until the pressure in the tank becomes 1 bar. NO significant heat transfer between the contents of the tank and the surroundings occurs. Assuming the ideal gas model with k=1.4 for the air, determine

(a) the final temperature in the tank, in degrees Celsius, and (b) the amount of air that leaks into the tank, in g.

Reference no: EM13545607

Questions Cloud

Derive a relationship to evaluate the discharge : Using Buckingham-Pi method, derive a relationship to evaluate the discharge, Q, over a rectangular notch as a function of the width of notch, b, acceleration due to gravity, g, fluid density

The circular cross section will be maintained during : A cylindrical rod of 1040 steel originally 15.2 mm (0.60 in.) in diameter is to be cold worked by drawing; the circular cross section will be maintained during deformation

Determine the normal depth of flow before and after the : Determine the normal depth of flow before and after the change in gradient. Will it be possible to produce a hydraulic jump in the channel downstream of the junction of two slopes?

Determine the depth of flow immediately upstream of the hump : A rectangular channel of 2 m depth and 5 m width carries 1 m deep running water. It is laid to a slope of 0.001 with Manning’s n = 0.02. Some distance downstream there is a hump of height 0.5 m on the stream bed

The final temperature in the tank in degrees celsius : A rigid tank whose volume is 10L is initially evacuated. A pinhole develops in the wall, and air from the surroundings at 1 bar, 25 degrees Celsius enters until the pressure in the tank becomes 1 bar.

Design the weir structure in order to accommodate the design : To avoid submergence the crest of the weir must be at least 0.05 m above the downstream water depth. Here we can assume that the depth downstream is equal to the normal depth. To simplify calculations we will assume that Cd = 0.7 Water depth over the..

Determine the pressure in the tank indicated by a strain : A single strain gage forming an angle B = 18 degrees with a horizontal plane is used to determine the gage pressure in a cylindrical steel tank. The cylindrical wall of the tank is 6mm thick, has a 600mm inside diameter

What is the function of a separation membrane between : A single strain gage is cemented to a solid 4-in diameter steel shaft at an angle B = 25 degrees with a line parallel to the axis of the shaft. Knowing that G = 11.6*10^6 psi, determine torque T indicated by a gage reading of 300*10^-6 in/in.

Draw the approximate positions of the water table for : For a cross section of a slope through a jointed rock mass, draw the approximate positions of the water table for the following conditions. (K = relative permeability)

User Account

All Pages