Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The vectors in the ordered set defined below were obtained by measuring the weight and ear lengths of toy rabbits and bears in the Fuzzy Wuzzy Animal Factory. The target values indicate whether the respective input vector was taken from a rabbit (0) or a bear (1). The first element of the input vector is the weight of the toy, and the second element is the ear length.
i. Use MATLAB to initialize and train a network to solve this "practical" problem.
ii. Use MATLAB to test the resulting weight and bias values against the input vectors.
iii. Add input vectors to the training set to ensure that the decision boundary of any solution will not intersect one of the original input vectors (i.e., to ensure only robust solutions are found). Then retrain the network. Your method for adding the input vectors should be general purpose (not designed specifically for this problem).
What is the exact height of a brick wall that is 44 courses high when three courses of brick plus their three mortar joints are 8 inches (203.2 mm) high?
Constructing the foundation causes changes in the levels of vertical stress at all points in the soil. One such point lies at the centre of the footing plan, and is at a depth of 10 m. Determine the increment of vertical stress there.
Is the system within membrane manufacturer's warranty requirement of maximum flux rate of 14 gfd? What is the annual power cost of the RO system?
Listed on cramster as ask. There is a car driving through water. Velocity is 12mph. Find h (max water depth) that will alow car to pass. List all assumption and calculations is the problem statement.
A 10m height chimney has a 2.0m x 2.0m square cross section. The wind blows horizontally in a direction which is parallel to one of the diagonals of the cross section.
A sedimentation basin is used to remove suspended solids from a wastewater. The rate of flow of wastewater into the tank is 10 L/s, and the influent concentration of suspended solids is 200 mg/L.
Explain why ductile metallic material is getting thinner in transverse direction when it is elongated in loading direction. Your answer should include entire mechanism of plastic deformation\
a rectangular beam with a width of a 8 in. an effective depth of 10 in., and a total depth of 12 in., is reinforced with a single fiberglass reinforcing bar that has a cross sectional area of 0.45 in^2.
Calculate the change in vertical effective stress on the roof of the culvert after installation. You can assume the sand above the groundwater level is saturated.
A hurricane has an average rainfall of 9 in over a 200 mile^2 watershed. What is the reservoir in acre-ft that would be required to contain 20% of the rain completely
Will the partial pressure of each component change? How about the pressure fraction of each component?
Consider a state with a total water withdrawal of 4.5 bgd in 2000. This was distributed as follows: municipal use 1.0 bgd, industrial use 1.5 bgd, and steam electric cooling 2.0 bgd
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd